Frigidaire 318200198, CPEB27S9FC5, CPEB27S9FC4 User Manual

ELECTRONIC OVEN CONTROL

Control Pad Functions

Read the instructions carefully before using the oven. For satisfactory use of your oven, become familiar with the

various functions of the oven as described below• Note: The graphics on your timer may not look like the one below• This doesn't change the way it operates• Start Time Pad- Used Cony Bake Bake Pad- Used Speed Clean Pad-- Use to to set the desired start Timer ON/OFF Pad- Usedto set or

Pad- Used to to enter the select the Speed Clean feature, time (Delayed Start) cancel the minute timer• The minute select the normal baking for baking or timer does notstart or stop cooking•

convection bake mode Preheat Pad- Bake Time Pad- cleaning. Can be feature. _ temperature• Used to select I Used to enter the used with PREHEAT Conv Convert_ \ the preheat _1length of the or any BAKING or

select the _ \ / _g Pad-- Use to \\ \ mode. ) baki t,me`/_ i LEANING cycle .

Convection \ /

• COtT_b_ke Nettoyage Bake tinl_ _" " " " Four a Co,ve_tlou _ ¢uis_on _¢ale " ' "

_i _eh_t Speed

Evem€ook Convection OvensConvert feature, _ \ / \

0 Thru 9 number pads- Used to enter temperature and times.

I 2 3

Pad-- Use to select the _

C°nsVtef_nre _.

Broil Pad-- Use to select variable Broil feature.

Clean Pad- Used to_ Clock Pad -- Use to select the self- eep Warm set the time of day.

cleaning mode. Maxx Clean Pad-- Use to OvenLight-

Pad-- Use to select the Used to turn select the Keep Warm the oven light

Maxx Clean feature, on and off. feature.

_ Heure_\ Clean Start time

Con_ Coast . Ne oya_-e_ KeepwarB1

Clear/Off- Used to cancel any function previously

entered except the time of day and minute timer. Push Clear/Off pad to stop

cooking.

4 5 6

7 8 9

All oven functions have a minimum and maximum time or temperature values that may be entered into the control. These values are shown below. If you have trouble setting a mode, be sure you are not entering a value greater then or lower than the values shown inthis chart. An ENTRY ERROR tone (3 short beeps) will sound if the value does not meet these limits.

MODE MINIMUM VALUE MAXIMUM VALUE

PREHEAT TEMP 170°F/77°C 550°F/288°C

BAKE TEMP 170°F/77°C 550°F/288°C

BROILTEMP 400°F/205°C 550°F/288°C

MINUTETIMER 12HR 0:01MIN 11:59HR/MIN

24 HR 0:01 MIN 11:59 HR / MIN

CLOCKTIME 12HR 1:00 HR/MIN 12:59 HR/MIN

24HR 0:00 HR/MIN 23:59 HR/MIN

BAKE TIME 12HR 0:01MIN 11:59 HR/MIN

24 HR 0:01 MIN 11:59 HR / MIN

CONVECTION BAKE 325°F/163°C 550°F/288°C

CONVECTION ROAST 325°F/163°C 550°F/288°C

Version en espafiol

Si desea obtener una copia

en espa_ol de este Manual del Usuario, sfrvase escribir

a la direcci6n que se incluye a continuaci6n. Solicite la P/

N 318200198E.

Start- Used to start all oven functions. Not used with

Oven Light,

Spanish Owner's Guides Frigidaire Company

P. O. Box 9061 Dublin, Ohio 43017-0961

318200198 (0408) Rev. A

Setting the Clock

Clock

The ,o,o_pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12hour operation. When the

range is first plugged in, or when the power supply to the range has been interrupted, the timer inthe display will flash along with "PF" (power failure, See Figure 1).

When PF appears in the display and 12:00 is flashing, press _ _

_,_i_,,•No sound will be heard,

but after 10 seconds a beep will sound and PF will disappear.

INSTRUCTIONS PRESS

To set the clock (example below for 1:30)

Press .o,_o_."CLO" will appear in the display (Figure 2).

2. Press 1 3 0 pads to set the time of day to 1:30 (Figure

3). "CLO" will stay in the display. Press 6_ART• CLO will disappear and the clock will start (Figure 4).

Changing between 12 or 24 hour time of day display

1. Press and hold ,_,_o'_for 7 seconds (Figure 3). After 7 seconds, "12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display

and the control will beep once.

2. Press _I[_, to switch between the 12and 24 hour time of day display. The display will show either "12Hr" (Figure 5) or "24Hr"

(Figure6).

Clock

Horl,_ge

13 0

c!,_ for 7 seconds

Clean

Nettewr

Figure 1

DISPLAY

Figure 2

Figure 3

Figure 4

Figure 5

3. Press to accept the change or press _%_,'_fto reject the change.

4. Reset the correct time as described in To set the Clock above.

Please note that if the 24 hour time of day mode was chosen,

the clock will now display time from 0:00 through 23:59 hours.

Figure 6

Setting the Clock (continued)

Setting Continuous Bake or 12 Hour Energy Saving

The TIMER ON/OFF ,_:,J,_,",_and CLEAN N_.ow,pads control the Continuous Bake or 12 Hour Energy Saving features• The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is

left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking•

To set the control for Continuous Bake or 12 Hour Energy Saving features

1. Press and hod On/0fffor 7 seconds (Figure1). After 7 seconds "12Hr" or "- -Hr" will appear in the display and the control will

beep once.

2. Press N_[_'_,to switch between the 12 Hour Energy Saving and continuous bake features. Note: "12Hr" (figure 2) in the display

indicates the control is set for the 12 Hour Energy Saving mode and %-Hr" indicates the control is set for the Continuous Bake

feature (Figure 3).

Timer _lean

INSTRUCTIONS PRESS DISPLAY

Timer

Nim,t_ri_

Tinier

0,,o, for 7

Mint_tede

seconds

Clean

Ndtowr

Figure 1

Figure 2

3. Press to accept the change (Figure 4; display will return

Figure 3

to time of day) or press ¢_c_{_,_,,_to reject the change.

Figure 4

Setting Timer

Tin;er

The TIMER ON/OFF ,,_,_'_,,,pad controls the Timer feature. The Timer serves as an extra timer in the kitchen that will beep when the set time has run out. It does not start or stop cooking. The Timer feature can be used during any of the

other oven control functions. Refer to "Minimum and Maximum Control Pad Settings" for time amount settings.

INSTRUCTIONS PRESS DISPLAY

To set theTimer (example for 5 minutes)

1. Press 0,,_'f 0"00 will appear and "TIMER" will flash in the

Timer

Minuted_ • •

display (Figure 5).

2. Press the number pads to set the desired time in the display

(example 5 ). Press The time will begin to count down with "5:00" and "TIMER" will stay in the display (Figure 6).

Minute, ie

Timer

0nlffff

Figure 5

Figure 6

Note: If isnot pressed the timer will return to the time of day after 25 seconds.

3. When the set time has run out, "End" and "TIMER" will show in the display (Figure 7). The clock will sound with 3 beeps every 7

seconds until ,,_'[_ Is pressed.

, Timer ,

To cancel the Kitchen Timer before the set time has

run out

Timer

Press M,,,,I,_,,_.The display will return to the time of day.

On Off

Timer

on/off

f4illuterie

Timer

01dOff

Mi,luterie

Figure 7

Consumer Defined Controls

Note: The Consumer Defined Control features are adjustments to the control that will not affect cooking results. These include the Oven Lockout, Silent Control Operation and Temperature Display features.

Setting Oven Lockout Feature

The _,_,_of!pad controls the Oven Lockout feature. The Oven Lockout feature automatically locks the oven door and prevents the Oven from being turned on. It does not disable the clock, Kitchen Timer or the interior oven lights.

INSTRUCTIONS PRESS DISPLAY

To activate the Oven Lockout feature

1. Press and hold _,,_,_for 3 seconds (Figure 1).

_,,,,_ for 3 seconds

2. After 3 seconds "LOC" will appear, a beep will sound and "DOOR LOCKED" will flash in the display. Once the oven door

Figure 1

is locked the "DOOR LOCKED" indicator will stop flashing and remain on along with the "LOC".

To reactivate normal oven operation:

1. Press and hold _,,,a_for 3 seconds. A beep will sound. "LOC" will disappear and "DOOR LOCKED" will flash in the display

until the oven door has completely unlocked (figure 2).

2. The wall oven is again fully operational.

_[_,a,i_°_!for 3 seconds

Figure 2

Setting Silent Control Operation

The STARTTIME ...... c_.,

feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.

_tari tinle

d_d_p_,and CLEAN _,_o_,pads control the Silent Control operation feature.The Silent Control operation

INSTRUCTIONS PRESS DISPLAY

To change control from normal sound operation to silent control operation

1. To tell if your range is set for normal or silent operation press

(:lean

Start tilr_

de d_part •

dean Figure 4

and hold ,..... "0:00" will appear and "DELAY" will flash in the

display (Figure 3). After 7 seconds ":SP" will appear in the display (Figure 4).

2. Press ,_,,o,_,to switch between normal sound operation and silent operation mode. The display will show either ":SP" (Figure

4) or ":--" (Figure 5).

If ":SP" appears (Figure 4), the control will operate with normal sounds and beeps. If ":- -" appears (Figure 5), the control is in the silent operation mode.

3. Press to accept the change or press to reject the change.

Figure 5

Consumer Defined Controls (continued)

Setting Temperature Display- Fahrenheit or Celsius:

The BROIL and CLEAN _I_,,_", pads control the Fahrenheit or Celsius temperature display modes. The oven control can be programmed to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to display

in Fahrenheit.

INSTRUCTIONS PRESS DISPLAY

To change display from Fahrenheit to Celsius or Celsius to Fahrenheit

To tell if the display is set for Fahrenheit or Celsius press (figure 1) and hold for 7 seconds; "550 °''will appear and

"BROIL" will flash in the display and a beep will sound. If "F"

appears, the display is set to show temperatures in Fahrenheit (Figure 2). If "C" appears, the display is set to show

temperatures in Celsius (Figure 3).

2. Press _4_4_'_to switch between Fahrenheit or Celsius display modes. The display will show either "F" (Figure 2) or "C"

(Figure3).

for7 seconds

Clean

Figure 1

Figure 2

Figure 3

3. Press to accept the change or press _,_! to reject the

STA_i

change.

Setting Oven Controls

Setting Preheat

The PREHEAT i_'_,t_,pad controls the Preheat feature• The Preheat feature will bring the oven up to temperature and then indicate when to place the food inthe oven. Use this feature when recipes call for preheating• Preheating is not

necessary when roasting or cooking casseroles• The oven can be programmed to preheat at any temperature between

170°Fto 550°F.

INSTRUCTIONS PRESS DISPLAY

To set the Preheat temperature for 350°F

1. Arrange the interior oven racks.

2. Press p_,_,_,.

3. Press 3 5 0 . "350°" and "BAKE" will appear in the

Note: After the oven has reached the desired temperature (this example, 350°F) the control will beep and the "PRE" light will turn off and oven temperature will be displayed (Figure 4). If you missed

hearing the beep, you can tell that the oven has reached preheat temperature if you see the oven temperature showing in the oven display. Once the oven has preheated, PLACE FOOD IN THE OVEN. The "BAKE" light will stay on.

Press ci_f_ ,^,h,, feature•

_'_h_ "- - -" and "BAKE" will appear in the display

(Figure1).

display (Figure 2).

"PRE" and "BAKE" will appear in the display as

the oven heats and reaches 350°F (Figure 3).

..... n baking iscomplete or to cancel the preheat

To change Preheat temperature while oven is

preheating (example: changing from 350°F to 425°F)

If it is necessary to change the preheat temperature while the oven

is preheating to the original temperature:

Figure 1

3 SO

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

1. ' " _l,_.t.....

While preheatlngp, tess ,__,_,,_,.- - - and "BAKE" will appear in the display (Figure 5)

2. Enterthe new preheat temperature• Press 4 2 5. "425°''

and "BAKE" will appear in the display (Figure 6).

3. Press "PRE" and will appear in the display as

the oven heats to 425°F (Figure 7). A beep will sound once the oven temperature reaches 425°F and the display will show

"425°''and "BAKE" (Figure 8).

4. When baking is complete press _:_°f

.... BAKE"

Figure 7

423

Figure 8

+ 12 hidden pages