Friedrich Metal Products PXCJA Installation Manual

Model PXCJA

Installation Instructions

CONDUIT KIT with JUNCTION BOX

For Use with Packaged Terminal Units

Please read these instructions completely before attempting installation.

NOTE: ALL ELECTRICAL WORK MUST CONFORM WITH LOCAL CODES AND ORDINANCES. THE
NATIONAL ELECTRICAL CODES, ANSI/NFPA NO. 70-19993 OR CURRENT EDITION, AND IN CANADA,
THE CANADIAN ELECTRICAL CODE PART I, CSA STANDARD C22.1-1993 OR CURRENT EDITION.

PDE or PDH MODELS

To install the line voltage power leads and conduit to chassis, follow the instructions below
and refer to Figures on following pages. PXCJA Conduit Kit is required with this setup.

Fig 1

1. Remove chassis’s front panel to expose the unit’s junction
box (Fig 1). Remove all 6 screws to junction box assembly.

920-119-02 (6-11)

Model PXCJA

2. Prepare the 265V (or 230V) power cord for
connection to the chassis’s power cord connector
by cutting the plug head to the appropriate length
(refer to Fig 2).

3. Route the cut end of power cord through the
locknut, spacers, conduit connector, bushing, and
flex conduit sleeve on the chassis’s junction box
(refer to Fig 3).

4. The lead cut end should pass all the way through
the opposite end of flex conduit sleeve into the
second bushing then between the elbow connector
housing. For wire protection, both bushing should
be inserted into the ends of the flex conduit sleeve.
Tighten the screws on elbow connector housing to
secure the conduit sleeve (refer to Fig 4).

5. Fasten and secure the elbow connector housing to
the wall junction box cover with locknut. Place and
mount wall junction box with all 4 mounting screws
making sure to pass the wall electrical lines through
the back opening of the junction box (refer to Fig 5).

Fig 3

Fig 2

Fig 4

920-119-02 (6-11)