Friedrich UE12D33D User Manual

93061001_01

For inner cleaning, contact an Authorized Service Center or a dealer. Do not use harsh detergent that causes corrosion or damage on the unit.

Harsh detergent may also cause failure of product, fire, or electronic shock.

CHECK FILTER & FILTER RESET

Check Filter: Your ‘Check Filter’ LED will light up after approximately 250 hours of operation, notifying you that your filter needs to be cleaned. Filter Reset: press ‘Temp ∨∧’ together to turn off ‘Check Filter’ light.

*Filter Reset must be done from unit control panel, not remote control

24

POWER

OPERATION MODE SELECTOR

Push the ‘Mode’ button to rotate between MoneySaver → Cool → Fan Only → Heat. MoneySaver: The fan will stop when the compressor stops cooling. The fan will turn on approximately every 3 minutes to sample to room air and determine if more cooling is needed. Cool: fan runs continually for normal cooling operation Fan Only: Fan-only operation Heat: Heater stops running after reaching desired room temperature, and the fan automatically stops after heater is turned off.

24

Push the ‘Mode’ button to rotate between MoneySaver → Cool → Fan Only → Heat. MoneySaver: The fan will stop when the compressor stops cooling. The fan will turn on approximately every 3 minutes to sample to room air and determine if more cooling is needed. Cool: fan runs continually for normal cooling operation Fan Only: Fan-only operation Heat: Heater stops running after reaching desired room temperature, and the fan automatically stops

after heater is turned off.

one

Battery

battery

the battery

is

battery

17

9

BRACKET

Install the new unit into the wall sleeve with 3/4" gap between sleeve and unit on left side (facing unit front).Next insert Around Insulation Strip 59 27/32" x 1 3/8" x 1 3/8" between gap in unit and sleeve pushing gasket 1" inside starting from lower left around top of unit down to lower right side.Tape off all around unit and sleeve.