Friedrich SL36N30, EL36N35, SS10N10, SL28N30, ES12N33 Installation

INSTALLATION INSTRUCTIONS

FOR DC-2 DRAIN KIT

STEP 1 Before sliding chassis into outer shell, turn chassis on its side and add drain hole by drilling

½” diameter hole as shown in Figure 1.

STEP 2 DC-2 mounts to the bottom of the outer shell as shown in Figure 2 on the right side as you face

the unit. Use two (2) 10 - 24 x 3/8” long machine screws and 10 - 24 hex nuts provided.

STEP 3 SQ, KQ, YQ Models - Drill two ¼” holes in outer shell as shown in Figure 3. Also drill a 3/8”

diameter hole in the base pan 3½” from the back and 3½” from right side.

STEP 4 Small and Medium Chassis Models - Mount in second and third holes from the rear of shell;

See Figure 4.

STEP 5 Large Chassis Models - Mount in third and fourth holes from the rear of shell; see Figure 5.

STEP 6 Connect a suitable length of garden hose or other tubing to end of the drain tube to drain the

condensate away.

FIGURE 1 FIGURE 2

RIGHT SIDE

APPROXIMATE
LOCATION OF
EMBOSSMENT.
DRILL 1/2” DIA.
HOLE

BACK OF BASE PAN

FIGURE 3

FIGURE 4 FIGURE 5

2ND & 3RD HOLES
FROM REAR OF
SHELL

10-24X 3/8” LONG
SCREWS

DRAIN PLATE

10X24 NUTS

3RD & 4TH HOLES
FROM REAR OF
SHELL

SQ, KQ, YQ MODELS

BOTTOM VIEW

1900235 (11-05)

SMALL & MEDIUM

CHASSIS MODELS

BOTTOM VIEW

LARGE

CHASSIS MODELS

BOTTOM VIEW