Freedom Innovations Plie 3 Owner's Manual

Owner’s Guide

MICROPROCESSOR KNEE

Inserting Batteries

1. To Open: Press down latch. The cap wil

l spring open.

2. Insert the battery, aligning the red dots. Be sure to properly fold

down the top portion of the battery label to ensure water
tightness. Also, be sure the gasket on the bottom side of the cap
is clean and free from dirt and debris.

3. Close the battery compartment by pressing firmly on the entire
cap until latch engages.

FREEDO M INN OVA TIO NS

Charging Batteries

For optimal performance, alternate batteries every day. To charge, align
the red dot on the battery with the red dot on the charger. A 12V car
charger is also included.

The Status LED will illuminate red if the charger has power. The Charge
LED wi

ll illuminate red , indicating the battery is charging. When the

battery is co

mpletely charged, the LED will illuminate green . If the Charge
LED stays red for more than four hours, this indicates that the battery is
either damaged or worn out. The temperature of the battery should be
kep

t between 8 °C and 38 °C (46 °F to 100 °F) while charging. If the

temperature goes outside this range, the Charge LED will shutoff

indicating that charging was stopped before the battery was fully
charged.

Battery Cap Closed