Freedom Venus Dining Chair Assembly Instruction

Assembly Instructions

Venus Dining Chair

Before you begin to assemble your new piece of furniture, please check to ensure that all parts have been supplied.

Follow instructions closely as deviation from them may void your warranty and present a possible safety risk.

It is recommended that assembly is done on a soft surface like carpet to avoid any damage.

If you experience any problems with your new purchase please phone our Customer Service Hotline [phone]
(Customers outside Australia should contact their closest Freedom store.)

Care Information

Periodically check and re-tighten any fasteners. Wipe down m

Hardware

etal and timber with a clean cloth.

2 x Small Bolt

Parts

2 x Medium Bolt

1 x Seat

1 x Large Bolt

1 x Front Leg1 x Front Leg

Step: 1

- Place the Seat on the edge of a table top as shown.
Use a towel or rug to protect the seat and table.

- Carefully align and lower the Front Leg frame onto
the Seat.

- Secure the Leg using the Small Bolt, Washer and
Spring Washer in the hole shown.

- Only loosely tighten the Bolt at this stage.

6 x Washer

Spring Washer

6 x Spring

Washer

Small Bolt

Washer

1 x Nut

1 x Allen Key

1 x Rear Leg

1 x Spanner

Front Leg

Page 1

Seat

Assembly Instructions

Step: 2

- Align the Rear Leg over the bolt holes of the Seat and
Front Leg.

- Secure the Leg using the Small Bolt, Washer and
Spring Washer in the middle bolt hole.

- Use the Medium Bolts, Washers and Spring Washers
for the two side bolt holes.

- Only loosely tighten the Bolt at this stage.

Venus Dining Chair

Medium Bolt

Rear Leg

Step: 3

- Insert the Large Bolt, Washer and Spring Washer
through the centre hole of the Legs.

- At the other end, secure the Large Bolt using
another Spring Washer, Washer and the Nut.

- Tighten Nut using the Spanner while firmly holding
the Large Bolt with the Allen Key.

- Once the Large Bolt is secure, fully tighten all other
Bolts using the Allen Key.

Page 2

Large Bolt