Freedom Rustic Extension Table Assembly Instruction

Assembly Instructions

Rustic Extension Table

Before you begin to assemble your new piece of furniture, please check to ensure that all parts have been supplied.

Follow instructions closely as deviation from them may void your warranty and present a possible safety risk.

It is recommended that assembly is done on a soft surface like carpet to avoid any damage.

If you experience any problems with your new purchase please phone Freedom Customer Service (FCS) on 1300 135 588
(Customers outside Australia should contact their closest Freedom store.)

Care Information

Periodically check and re-tighten any fasteners. Protect from direct and in-direct sunlight. Wipe down timber weekly using a
clean cloth. Use a Freedom recommended polish every three months. When moving the table, lift rather than drag it.

Hardware

8 x Bolt 8 x Washer 1 x Spanner

Step 1.

Place the table on a soft surface with the underside of the table facing up (as shown in the picture below).

Step 2.

Place Washer over bolt. Align the leg with the corner block.

Step 3.

Tighten Bolts in a clockwise direction using the Spanner supplied. Repeat for each leg.

Step 4.

Carefully lift the table onto its legs (this should be done by at least two people).

Page 1

Unlocking the Extension Clips

Locked Unlocked

Operating Instructions

Rustic Extension Table

Extending the Table (requires two people)

Step 1. Step 2.

Unlock the four Extension Clips. Pull each half of the
table top back (one person at each end of the table).

Step 3.

Pull the extension leaves out until they rest on
on the apron of the table.

Step 4.

Push back each half of the table top towards
the extension leaves

Page 2

Lock the four Extension Clips before use. Reverse the
steps to un-extend the table