Freedom Lever Table Lamp Assembly Instruction

BLF1102014 Lever Table Lamp

Assembly Instructions

2.Remove the table lamp from the packaging

5.Ensure the power is switched off at the wall

hild

Please read all instructions before commencing installation even if you feel you are quite familiar with this type of product.

WARNING:

• This table lamp must be connected to a 240V 50Hz power source.

• Ensure that the switch is in the off position and the plug is removed from the wall socket when changing light globes.

• Light globes are extremely hot when in use. Always remove globes only when they have cooled to room temperature.

• This table lamp is not intended for use by children or infirm persons without supervision.

•

oung c

DO NOT play with this table lamp.

• This table lamp is not designed for outdoor use.

• Ensure that the globe is at least 30cm from the

nearest object at all times.

ren should be supervised to ensure they

Assembly instructions:

1. Follow these instructions closely as deviation may void your warranty and present a possible safety risk.

and dispose of packaging materials thoughtfully.

3. Before you begin to use this table lamp check all parts have been supplied.

4. It is recommended that any assembly is performed on a soft surface to avoid any damage.

socket and DO NOT connect at this stage.

6. Fit the shade to the lamp holder by removing the ring ‘A’, fitting the shade ‘B’ over the threaded section of the lamp holder ‘C’ and replacing the ring ‘A’.

7. Screw the pole ‘E’ onto the fitting ‘D’ making sure that the thumb screw ‘F’ is loose so that the

ole ‘E’ can turn freely. Do not hold F and

H when screw the pole “E” onto the fitting “D”.

8. Tighten thumbscrew ‘F’ at a point where the clamping bracket is halfway between the top and the bottom of the tube ‘E’.

9. Screw the pole ‘I’ to pole ‘E’ making sure that the guide ‘G’ is fitted over pole ‘E’.

10.Screw the base ‘J’ to the bottom of pole ‘I’.

11.Draw the cable down throu and secure the cord anchorage screw ‘K’ adjusting the angle of the lever pole so that it is at approximately 15 degrees from horizontal.

12.After initial assembly adjust the angle of the lever pole by releasing the thumb screw ‘F’ and sliding the adjustment assembly up and down.

13.Screw the E27 25W CFL max (not included) into the lamp holder ensuring that it is secured firmly. Do not over tighten.

14.Plug the cord into the selected wall socket, turn the wall socket on and switch the table lamp ON using the switch located on the cord.

SPECIFICATIONS: Fitting: Metal table lamp with metal

shade head.

Globe: 240V E27 max 25W CFL Construction: Class II

h the small tube