Freedom Gem String Lights Assembly Instruction

Instructions

Gem String Lights

Pease read the following carefully to ensure the satisfactory and safe operation of these lights.

Follow instructions closely as deviation from them may void your warranty and present a possible safety risk.

If you experience any problems with your new purchase please phone Freedom Customer Service (FCS) on 1300 135 588
(Customers outside Australia should contact their closest Freedom store.)

Instructions for Use

This set of lights is fitted with LED bulbs, it is important to follow these instructions to ensure the satisfactory and safe operation
of these lights in use. This set has been designed so that under normal conditions, if a bulb fails the remaining bulbs should stay
alight. A defective bulb CANNOT be removed and replaced.

For Safety's Sake

For indoor use only

Do not operate this set in the packaging

Do not operate in moist or very humid conditions

Disconnect from mains when not in use

Avoid damage to the wiring insulation

As with all electrical equipment, cable and fittings should not be exposed to direct heat or flame

Ensure adequate airflow around each lamp

Do not connect this set electrically to another set

For use only with the transformer supplied. Do not connect directly to mains supply

If light chain is damaged, light set should be disposed of

Bulbs can not be replaced

Please keep this information for reference

Transformer

This set is supplied with 24V DC 3.6W transformer and should only be used with this transformer

Important

THIS SET IS SUITABLE FOR INDOOR USE ONLY. DO NOT USE OUTDOORS

Specification

 Bulb Rating: 3V 0.06W x 40 (Not Replacable) Transformer Input: 240V ~ 50Hz

 Bulb Spacing: 6cm    Transformer Output: 24V DC 3.6W Maximum 2.4W

 Lead Wire: 5m     Model No.: JT-DC24V0150

 Approval No.: N15922

Page 1