Important, Keep for
Future Reference
Assembly
Instructions
Advance Mobility
Freedom
2 1
• To assemble, simply unfold frame...
Frame
• Important, keep this booklet for future reference.
• Accessories which are not approved by the manufacturer or distributor
should not be used.
• WARNING: Prevent serious injury to your passenger by always using the
safety harness.
• WARNING: Any load attached to the handle affects the stability of the stroller.
• WARNING: Do not leave passenger unattended.
• Always use your wrist strap – these Push Chairs can really roll, and the
wrist strap gives you control if you should slip or fall down.
• The passenger should remain seated at all times (no standing in the Push Chair).
• Watch out for cars – never assume that a driver can see you and your passenger.
• Never use Roller Blades while using the Advance Mobility Push Chair.
• Total weight load recommended for this Push Chair is 200 lbs.
(combined passenger and baggage weight).
• This Push Chair seats one passenger.
• WARNING: Recommended weight for seat pocket is 2 pounds and basket
is 10 pounds. Excessive weight may cause a hazardous unstable
condition to exist.
• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer.
For the sake of your precious cargo, please read
these warnings before using your Push Chair.
2 3
• Swing bottom frame tubes toward footplate.
• Insert bottom of footplate into front tube connectors.
• Push up to secure snap locks on both tubes.
Frame
Frame
Snap
Locks
• Swing side braces down
to mounting brackets.
• While pushing latch button
slide side brace over
mounting bracket, release
when pin is aligned with
hole in bracket.
• Secure side brace clamp.
Repeat on both sides.
Side
Brace
Front Tube
Connector
4 5
1 To install front wheel, lay Push Chair back
so handle is resting on floor. Open the
calipers by flipping the caliper lever toward
the rear.
2 Insert the front wheel assembly into
the front frame tubes until pin holes
are aligned.
3 Insert wheel pin on each side.
4 Close caliper by flipping the caliper lever
toward the front.
1 To install front swivel wheels, lay Push
Chair back so handle is resting on floor.
2 Insert the front wheel assembly into
the front frame tubes until pin holes
are aligned.
3 Insert wheel pin on each side.
Front Wheel
Front Swivel Wheel
Caliper Lever
6 7
• Simply adjust seat straps to
desired degree of recline.
• Pull on strap when you
want to return the seat to
its upright position.
Reclining Seat
Be sure to remove the board from the back of the seat before washing.
• To install, gently slide the
wheel’s axle into the hole
in the axle end until you
hear it click into place.
• To remove, simply push in
the spring lock while
pulling out the wheel.
Rear Wheels
Spring
Lock
Spring
Lock
8 9
Adjusting the Brake
• If you don’t have good braking action,
simply squeeze the brake handle five or
six times. If the problem persists, loosen
the brake’s cylinder ring to adjust the
small ring, and then move the small ring
away from the handle to tighten the
cable. (Please do not over tighten!) To
lock the rings, tighten the cylinder ring
against the handle while holding the
small ring in place.
Hand Brake with Parking Button
• To use the parking button feature, simply squeeze the brake handle and push the park brake button.
Hand Brake
Small
Ring
Cylinder
Ring
Parking
Button
Safety harness:
• Clip shoulder straps to upper fabric loop that best suites passenger then attach lower clips to
buckle bracket.
• Adjust center safety strap as necessary for passenger comfort.
Safety Harness
WARNING: Avoid serious injury from falling or sliding out.
Always use safety harness!
10 11
1 Using a phillips head screwdriver, screw brackets to Push Chair frame.
3 Fasten upper velcro straps
Canopy
Image shown with seat fabric removed for clearer viewing.
2 Snap to Push Chair frame.
NOTE: Some Push Chairs
are shipped with the
Canopy, Seat and Basket
pre-assembled. Assembly
instructions are given if
any pre-assemble items are
removed for cleaning or
replacement.
Rear Wheel
Parking Brakes
• Simply push brake pedal down to engage
brake and lift up to release.
Brake
Pedal
Rear Parking Brake
12 13
Washing
• You can machine wash your Push Chair's seat in cold water with a mild detergent.
To minimize shrinkage, simply reattach the seat to the frame to dry.
(Please do not put the seat in the dryer!)
• Be sure to remove the board from the back of the seat
before washing.
• You may clean the Push Chair's frame using a soft, dry cloth,
and an occasional spray of household wax will maintain its
healthy glow.
Wheel Care
• Moisture – especially from the beach – can rust the wheel bearing case.
Spraying regularly with a silicone lubricant will keep your wheels looking healthy.
• Also, if you use your Push Chair for large amounts of miles, your
Push Chair will benefit from a yearly visit to the bike shop for wheel
alignment. Refer to the number on the tire wall for the optimum
pressure for your tires.
Storing
• Sunshine can fade seat fabric and dry out tires, so storing your Push
Chair indoors will prolong its good looks. However, if you do store it
outside, using a tarp will protect against weather wear.
Push Chair Care
Steering
• Steering your Push Chair is simple: it’s balanced to
turn with just a light touch on the handlebar.
For tighter turns, push down on the handlebar
and raise the front wheel to steer.
Wrist Strap
• Make sure wrist strap is around your wrist whenever your
passenger is in the Push Chair. The Advance Mobility Push
Chair is lightweight and ready to roll – with or without you –
and the wrist strap helps you gain control over your Push Chair.
In the Dark
• Since we are concerned about the safety of you and your
passenger, we recommend that you not use your Push Chair at
night. However, if you choose to, please attach reflective strips
to the wheel spokes and the seat. Bicycle lights can also be
mounted on the handlebar.
In Motion
We wish you many happy journeys with your new
Advance Mobility! Your Push Chair is a great product,
and we are proud to manufacture it. If you have any
questions or comments, please give us a call at:
BJC AM Freedom 05.30.08
1.800.241.1848
Advance Mobility is a Division of Baby Jogger
8575 Magellan Parkway, Suite 1000 • Richmond, VA 23227
T: 800.241.1848 • F: 804.262.6277
www.advancemobility.org
Thank You!
Loading...