Fredenstein Bento 10 User Manual

Bento 10

Module Carrier

Operating Manual

Fredenstein Bento 10 Module Carrier

The Fredenstein Bento 10 is a high performance module carrier for Fredenstein Series 600 modules
or API-500 compatible plug-in cards in two space 19 inch rack format. The unit accepts a maximum
of 10 modules. The Bento 10 features several important upgrades compared with third party
products:
Universal power supply: accepting mains voltages from 90V AC to 240V AC, 50 to 60 Hz.
Increased output currents: +-16V DC 3.2A and +48V DC 0.3A
Auxiliary Audio Inputs and Outputs
Built-in Audio Routing: Modules can be daisy-chained by simply flipping switches on the back­panel.
Compressor buss linking: Compressor modules can be linked by engaging switches on the back­panel as well.
Multi-Layer Backplane: Increased signal integrity and lower noise floor.
Ground-lift switch: In case of ground loops, the audio ground and the protective ground can be
disconnected. Please use only if absolutely necessary.

Installation:

Electrical Safety Warnings:
Do not open the enclosure, hazardous voltages are present inside!
There are no user serviceable parts inside.
Always disconnect the mains cord before installing or removing modules!
If you need to replace the mains fuse, make sure the replacement has the same
rating (2AT).

Please disconnect the mains from your Bento 6 before installing or removing modules. Make sure
each installed module is well seated in the receiving connector and the module is secured by fasten
the two mounting screws.

Front View:

Fredenstein Bento 10 Manual V1.1 July 18, 2014 Page 1