Franklin Cape Range Liability 1013 User Manual

User Manual

INSIDE THE BOX

 Device
 Power adaptor
 USB
 Cable

CONNECTING DEVICE

1. To turn on your device, press and release the power button. To put it in sleep mode, press and

release the power button.

2. To turn off your device, press and hold the power button until a message displays asking if you

want to shut down.

3. Your device will be partially charged when you receive it. To charge your device, connect one

end of the USB cable into your device and the other end into the power adapter (included).

4. Connect the power adapter into a nearby power outlet.

CONNECTING DEVICE TO YOUR HOME NETWORK

Tap the quick setting icon located on the status bar to display settings for the most commonly
performed tasks

Select wireless network to toggle wireless to toggle wireless on or off, display a list of detected Wi-Fi
networks, add a network, and access advanced wireless settings.

REGISTERING YOUR DEVICE

To use many of the device features, you must register it to your account. If you have not yet registered,
please do so now. Prior to registering, connect to a Wi-Fi network by tapping the Quick Setting icon at
the top of the device, then Wi-Fi. Select the network you want to use. Once you are connected, tap the
Quick Settings icon, then more, and select the My Account option to register.

Product Information

Safety and Compliance Information
Using Your Device Around Other Electronic Devices

The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its
instructions, may cause interference to radio communications and electronic equipment. External RF
signals may affect improperly installed or inadequately shielded electronic operating systems,
entertainment systems, and personal medical devices.

While most modern electronic equipment is shielded from external RF signals, if in doubt, check with
the manufacturer. For personal medical devices (such as pacemakers and hearing aids), consult with
your physician or the manufacturer to determine if they are adequately shielded from external RF
signals.

There are some places where RF signals could constitute a hazard, such as health care facilities, and
construction sites. If you are not sure, look around for signs indicating that two-way radios or mobile
phones should be turned off.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

FCC Compliance Information

Radio Frequency Information

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.