Franke Foodservice FDL 664 Installation Manual

Instructions for use and installation

GB

Cooker Hood

FDL 664
FDL 764
FDL 964

EN

Instructions Manual
INDEX

WARNINGS - COMPONENTS............................................................................................................................................10

INSTALLATION....................................................................................................................................................................11

USE - MAINTENANCE ........................................................................................................................................................12

3
3

EN

1

WARNINGS - COMPONENTS
WARNINGS

This appliance has been designed for use as either an EXTRACTION (ducting to the outside)
or RECIRCULATION (filtering) hood. The measurements contained on the drawings in this
booklet refer to two models of cooker hood. Therefore, it is essential that you refer to the cor­rect drawing when taking measurements for installation.

- The minimum distance between the cooking surface and the metal grease filters on the
underside of the hood must be 650mm.

- This cooker hood must be installed in accordance with the installation instructions and
all requirements must be adhered to.

- If the room where the cooker hood is to be used contains a fuel burning appliance such
as a central heating boiler then its flue must be of the room sealed or balance flue type.

- If other types of flue or appliances are fitted ensure that there is an adequate supply of
air to the room.

- When the cooker hood is used in conjunction with appliances supplied with energy
other than electricity, the negative pressure in the room must not exceed 0.4 mbar to
prevent fumes being drawn back into the room by the hood.

- The ducting system for this appliance must not be connected to any ventilation system
which is being used for any other purpose.

- The ducting system for this appliance must not be connected to any existing ventilation
system which is being used for any other purpose.

- Do not leave naked flames or carry out flambè cooking under this cooker hood.

CONNECTION TO THE MAINS WARNING: DOUBLE INSULATED DO NOT EARTH

Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on
the rating plate inside the hood.
This appliance is fitted with a 2 core mains cable and must be permanently connected to the
electricity supply via a double-pole switch having 3mm minimum contact gap on each pole.

COMPONENTS

- 2 No Wall Brackets C

- 1 No 150-120mm Ducting Spigot G

- 1 No Air Outlet Connection H

- 2 No Charcoal Filters L (Optional)

10