Franke UK Limited
West Park, MIOC
Styal Road
Manchester M22 5WB
www.franke.co.uk
Service & Spares:
Central Services 01782 599 258
mail@central-servicesuk.co.uk
South Services 0870 241 5632
sales@south-services.co.uk
www.south-services.co.uk
FR010709 Davos J Install 5/1/07 12:14 Page 2
$
$
140.85
1
0
0
.
0
0
54.50
3
8
1
.0
0
220.00
244.00
Franke Specialist Range
Davos ‘J’ Tap
Installation Instructions
For kitchens without compromise.
FR010709 Davos J Install 5/1/07 12:14 Page 3
$
Preparation
First shut off your water heating system then, with your
mains stop cock closed, open the lowest hot and cold taps
in the house and allow to run until the cold storage tank
and pipes are empty. (The hot water storage cylinder
always remains full).
Installation
First screw the threaded stud into the mixer body. Screw
the copper tails into the mixer body and fully hand tighten.
After making any necessary alterations to existing
pipework, fit in position.
When the tap is in position (with the cold side on the right
when viewed from the front) slide the nylon bracing plate
up to the underside of the sink together with the retaining
plate, and secure by screwing the fixing nut finger tight.
Check that the mixer body and plinth are correctly
positioned and fully tighten fixing nut.
It is recommended that 15mm x 15mm compression
fittings be used to connect mixer to supply pipes. Cold is
connected to the right and hot on the left when viewed
from the front.
Attention
Before installing the new mixer it is essential that you
thoroughly flush through the supply pipes in order to
remove any remaining swarf, solder or other impurities.
Failure to carry out this simple procedure could cause
problems or damage to the workings of the mixer.
Having first checked all new connections, turn on the
mains stop cock, close all taps except the new mixer and
as the system starts to refill check for leaks.
Once you have satisfied yourself that there are no leaks,
switch on the water heating.
Guarantee
Your Franke mixer has been manufactured to the high
standard you would expect of any Franke product but in
the unlikely event that you should experience any defect
in the materials or workmanship within one year of
purchase, we will replace the faulty part free of charge.
This is provided the mixer has only been used for normal
domestic purposes in the UK and that the care,
installation and maintenance instructions have been
observed.
This one year guarantee is extended to five years in the
case of the valve mechanism.
You should also retain your dated invoice as proof of
purchase to validate any claims under our guarantee.
Normal wear and tear is excluded from the guarantee.
Decorative surface finishes are guaranteed for one year
from the date of purchase provided our advice
concerning care has been observed and no scouring
agents have been used.
Scuffs and scratches caused by improper installation or
accidental damage are not covered by this guarantee.
Neither are slight shade variations or any damage or
defect caused by incorrect installation or abuse of the
fitting.
Design
These mixers are available in Chrome or SilkSteel to
coordinate with Franke sinks.
Service
In the event of parts or service being required, please
contact:
Central Services Telephone 01782 599 258 or
South Services
Telephone 0870 241 5632
See over for installation instructions.
FR010709 Davos J Install 5/1/07 12:14 Page 4
$
$
Warning
These hints have been prepared for your guidance, you
must exercise due care at all times. We do not accept
responsibility for any problems that may occur through
incorrect installation.
How to care for your kitchen sink mixer
To maintain the appearance of this fitting, ensure it is
cleaned only using a clean, soft damp cloth. A solution of
warm water and mild liquid detergent may be used where
necessary, and then the fitting rinsed thoroughly.
Abrasive cleaners or acidic cleansers MUST NOT BE USED
under any circumstances. Avoid contact with all solvents.
Technical data
Maximum water pressure: 75 PSI (5 bar)
Maximum hot-water temperature: 70°C
Recommended hot-water temperature: 65°C
Note: If these temperatures or water pressures are
exceeded damage to the tap can result.
A pressure reducing valve may be required to be
fitted in high water pressure situations.
Recommended Parts List
2299R+colour Spout
1263R+colour Perlator
2300R O-ring kit
3035R C Cold Handle
3035R H Hot Handle
1427R C Cold Valve
1427R H Hot Valve
3037R Fixing Kit
1234R Copper Tails
FR010709 Davos J Install 5/1/07 12:14 Page 5
$
1263R
=~
rif\[gffi,,L_o
LLJ
~-~,.
2300R
~
_7_l__
____
_
---0
~
2299R
3035R
1427R-H
1427R-C
$
fT---------11
G~D
-=---=----=--
--- _- _- -~
'037R
1234R
Check out our full range of Kitchen Products
Kitchen Sinks
Stainless Steel Kitchen Sinks
Granite Composite Kitchen Sinks
Glass Kitchen Sinks
Ceramic Kitchen Sinks
Franke Kitchen Sinks
Kitchen Taps
Contemporary Kitchen Taps
Traditional Kitchen Taps
Franke Kitchen Taps
Pull out Rinser Kitchen Taps
Instant Boiling Water Taps
Insinkerator Waste Disposal Units
Loading...