5
a properly installed fused socket. The power supply (AC) and voltage
at the operating point must match with the details on the name plate of the appliance (the name plate is
located on the inside left of the appliance).
or any damages that occur due to ungrounded usage.
away from electrical ovens.
Your fridge should never be used outdoors or exposed to rain.
humidity forming on the outer surface.
all your fridge in a suitable place so that at least 15 cm of free
space is available above it.
turning them in either direction. This should be done before placing food in the fridge.
bicarbonate, then rinse with clean water and dry. Place all parts in the fridge after cleaning.
plastic distance guide (the part with black vanes at the rear) by turning it 90° (as shown in the
figure) to prevent the condenser from touching the wall.
Before using the appliance
3 hours before plugging into the mains. This allows efficient operation and prevents damage to the
compressor.
away when your fridge starts to cool.
LESS FROST TECHNOLOGY:
Thanks to the wrap around evaporator, LessFrost technology offers more efficient cooling, less manual
defrosts requirement and more flexible storage room.
Thermostat setting
The thermostat automatically regulates the temperature inside the refrigerator and freezer compartments.
Cooler temperatures can be obtained by rotating the knob to higher numbers, 1 to 5.
Important note: Do not try to rotate the knob beyond position 1, it will stop your appliance from working.
Thermostat settings
-term storage of food in the appliance.
-term storage of food in the appliance.
Super freezing:
This switch shall be used as superfreeze switch. For maximum freezing capacity, please turn on this switch
before 24 hours placing fresh food. After placing fresh food in the freezer, 24 hours ON position is generally
sufficient. In order to save energy, please turn off this switch after 24 hours from placing fresh food.
Warnings about Temperature Adjustments
the temperature in the refrigerator compartment. If required, change the temperature setting.