12
When the appliance is cooled or warmed (due to expansion of appliance material).
Short cracking: Heard when the thermostat switches the compressor on/off.
Compressor noise
Bubbling noise and splash:
is caused by the flow of the fridge freezer in the tubes of the system.
If you hear any other noises check that:
--The appliance is level
--Nothing is touching the rear of the appliance
--The objects on the appliance are vibrating.
Water flow noise: Normal flow noise of water flowing to the evaporation container during defrosting. This
noise can be heard during defrosting.
Air Blow Noise: Normal fan noise. This noise can be heard in fridges during normal operation of the system
due to the circulation of air.
If there is water in the lower part of the refrigerator
Check that:
Recommendations
example during the summer holidays) unplug
and clean the appliance and leave the door open to prevent the formation of mildew and smells.
open).
If a problem persists after you have followed all the instructions above, please consult the nearest
Authorised Service Centre.
by the Department of Industry. The length of time for
retaining parts required for the proper operation of the appliance is 10 years.
Tips for saving energy
1. Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near a heat source
(radiator, cooker, etc.). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low temperature of the frozen
food will help to cool the refrigerator compartment when it is thawing. This will help to save energy. If the
frozen food is put out, it results in a waste of energy.
4. Cover drinks or other liquids when placing them in the appliance Otherwise humidity increases in the
appliance. Therefore, the working time gets longer. Also covering drinks and other liquids helps to preserve
smell and taste.
5. Try to avoid keeping the doors open for long periods or opening the doors too frequently as warm air will
enter the cabinet and cause the compressor to switch on unnecessarily often.
6. Keep the covers of the different temperature compartments (crisper, chiller ...etc.) closed.
7. Door gasket must be clean and pliable. Replace gaskets if worn.
8. It is possible to store more food by removing freezer shelf. Energy consumption is declared with maximum
load and without freezer shelf.
9. For saving energy, do not use volume between the load limit and the door, along the load limit line. Load
limit line is also used in energy consumption declaration.
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the following data available: Model
and Serial Number.
The information can be found on the rating plate. Subject to change without notice.
TECHNICAL DATA
The technical information is situated in the rating plate on the internal side of the appliance and on the
energy label.
The QR code on the energy label supplied with the appliance provides a web link to the information related
to the performance of the appliance in the EU EPREL database.
Keep the energy label for reference together with the user manual and all other documents provided with
this appliance.