FPV Model X-Racer X9 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

FPVMODEL LIMITED

http://www.fpvmodel.com

Step 1：Check all the parts in case there’s any missing.

1 x X-Racer X9 Frame
4 x Dragonfly MC1105 7500kv Motor
1 x Raceflight Millivolt Flight Controller
1 x Raceflight Spark 4n1 ESC
1 x RunCam Micro Swift 2 FPV Camera (Update on September 12th.)
1 x Dranonfly 5.8g 25MW 48CH Vtx
4 Pairs x GemFan 2035BN 4-Blade Propellers
1 x 16AWG Silicon Wire
1 x Amass XT30 Plug Male
16 x M2*4 Screws
16 x M2*6 Screws
10 x M2*7 Screws
4 x M3*18 Screws
7 x M2*19 Aluminum Standoff
10 x M3 Black Nylon Nut

Step 2：The wire lengths that you need to keep after cutting.

Black wire: 44mm
Red wire: 38mm
Please keep 35mm motor wires, including the heat shrinkable tubes

Step 3: Connect motors and flight controllers

The parts you need are shown as below:

Connect the flight controller to 4 in 1 ESC, make sure the 10 pins and holes are matched.

Solder power supply cable and make sure the connection of FC & ESC is correct.
Solder the motors onto the ESC, and then solder XT30 cable onto the ESC. Black for“-” and Red for
“+”.