Foxpro 650 User Manual
FOXPRO Jack Daddy Operation Instructions
To avoid personal injury and prevent product damage, read all operating instructions and safety
precautions prior to use. Please note that these instructions may be modified without notice. It
is recommended to periodically check the instructions to be aware of any recent changes.
Important Information
FOXPRO®’s goal is to provide our customers with the highest quality products in the
industry. We take great pride in manufacturing our products in the USA. Please do not
hesitate to contact us for assistance, comments or questions.
FOXPRO® Inc.
14 Fox Hollow Drive
Lewistown, PA 17044
(717) 248-2507
Fax: (717) 247-3594
Hours of Operation
Monday – Friday
8AM – 5PM EST
Contact Us
Customer Service: (717) 248-2507
Toll Free Orders Only: 866-463-6977
General Inquiry E-mail: sales@gofoxpro.com
This manual, the animal sounds stored in your caller, and animal sounds purchased from
FOXPRO® Inc. for installation in your caller are protected by copyright.
Copyright ©℗ 2014 by FOXPRO® Inc.
REV4 - Publication Date: September 10, 2014
Jack Daddy Requirements
The Jack Daddy is shipped without batteries. The Jack Daddy requires 4 ‘AA’ batteries.
Installing batteries in the Jack Daddy
1. Access the battery compartment by removing the door on the back of the Jack Daddy.
The door features a knurled thumbscrew for easy access.
2. After the door has been removed, locate the black plastic battery tray. The tray is
double-sided, providing spaces for 4 ‘AA’ batteries. The tray can be pulled directly out
of the battery compartment. Remove the tray from the compartment.
3. Place the batteries into each battery cavity while observing polarity as indicated.
4. Place the battery tray back into the compartment
5. Secure the door back to the Jack Daddy.
Jack Daddy Remote: Requirements
The Jack Daddy Remote contains a single lithium coin cell battery (CR2032). To replace the
battery, follow the instructions below:
1. Before attempting to replace the battery, it is crucial that you understand the risks
of electrostatic discharge potentially harming the electronic board during battery
replacement! Prior to replacing the battery, make sure that you are static free. You
can touch your hand to a refrigerator door, oven housing, door knob, etc. If you have
the ability to use a proper grounding wrist strap, please do so.
2. Carefully separate the Jack Daddy Remote into two halves. This can be accomplished
with a flathead screwdriver or other comparable tool.
3. Locate the battery and carefully remove it from the board by sliding it out of the
holder. Note battery orientation as you remove it as the new battery must go back in
the same way.
4. Carefully slide the new battery into the holder.
5. Place the circuit board back inside the appropriate case half.
6. Line the two halves up together and snap them shut to form a single device once
again.
Setting Up the Jack Daddy
The following instructions apply whether you are using the Jack Daddy as a standalone device or
linked-up with a FOXPRO digital game call. Basic field deployment instructions:
1. Locate the mounting stake on the left side of the housing. The Jack Daddy sits upon
this stake in the field.
2. Unscrew the mounting stake from the housing.
3. Screw the stake into the mounting point on the bottom of the Jack Daddy.
2
Loading...