Foxfury Lighting Solutions Taker B70 Product Manual
PRODUCT MANUAL
480-600
TAKER B70
TABLE OF CONTENTS
INTRODUCTION
Taker B70 Reference Guide 3
Physical Characteristics & Warnings 4
BATTERY
Battery Installation and Replacement 5
Battery Life 6
OPERATION
Operational Modes 6
FEATURES
Ambidextrous Light Activation 7
Pressure Switch 7
Individual LED Rows 8
Dual Settings 8
INSTALLATION
Shield Installation 9
Wiring Installation 10-11
WARRANTY 12–13
CONTACT FOXFURY 13
3
TAKER B70 REFERENCE GUIDE
SHIELD LIGHT
(WITH PROTECTIVE COVER ON)
SHIELD LIGHT
(WITH PROTECTIVE COVER OFF)
+ +
– –
+ +
– –
HANDLE
(BACK SIDE)
PROTECTIVE
COVER
LEDs (6)
PROTECTIVE
LENS (2)
WIRE
HOLES
(4)
TERMINAL
BLOCKS (4)
POWER/MODE
SWITCH (2)
BOLT HOLE (2)
BATTERY
DOOR (2) GRIP
SCREWS (10)
BOLT
HOLE (2)
WIRE
THROUGH
HOLES (4)
4
PHYSICAL CHARACTERISTICS
Please read below before using the Taker B70 as it relays beneficial operating
and safety information.
SHIELD LIGHT (P/N 600-480-300)
DIMENSIONS (WxH) 6.3 x 2.5 in (160 x 2.5 mm)
WEIGHT
35.2 oz (998 g)
HANDLE ONLY (P/N 60-601)
DIMENSIONS (WxH) 5.5 x 4.3 in (127 x 109 mm)
WEIGHT 19.2 oz (554 g) with batteries
WARNINGS
Do not stare into LEDs for long periods of time or from a close range
(less than 2 ft (.06 m)).
FoxFury’s Turbo-Strobe™ is purposely designed to induce disorientation.
Prolonged viewing may produce vertigo or even vomiting.
Do NOT attempt to charge the batteries by using the Pressure Switch
Port.
!
!
!
INCLUDED
Handle with Electronics & Pressure Switch (P/N 60-601)
Dual Discover Shield Light Head (P/N 600-480-600)
5
BATTERY INSTALLATION AND REPLACEMENT
1. Twist the Battery Door (at both ends of the handle) in a counter-clockwise
direction to remove them.
2. Insert three (3) batteries (with the negative end first) into either side of the
handle (respect appropriate polarity when installing).
If installing six (6) batteries (doubling battery life), then repeat step 2
one more time on the opposite side of the handle.
3. Re-install the End Cap(s) by twisting in a clockwise direction (make sure
the End Cap(s) are tightly sealed).
Test the light’s performance and function by activating the Power/
Mode Switch (located under the Grip).
BATTERIES
The Taker B70 uses three (3) or six (6) CR123 batteries. As long as there
are at least three (3) installed, the light will function.
Using three (3) CR123 batteries decreases the battery life by half, but
does not effect the light intensity.
Mixing of new and used, or different brand batteries is not recommended
as this could lead to leakage or explosion.
1
2
1
2
3
3
+ –
+ –
+ –
+ –
+ –
+ –
Loading...