Fownes Brothers and KBJ-103N User Manual

Bluetooth Earwarmer

www.fownesbrothers.com

Thank you for selecting our latest Bluetooth headset, please
read this User's Manual carefully before you operate this
headset, and please save this Manual for further reference.
Before operating, please read all the Safety notice to ensure
the safe and appropriate use.

Safety Notice:

Please observe the rules of the Count ry or Region which you
are in while driving.

Do not disassemble or modify the headset for any reason,
otherwise, It may damage the headset.

Please keep the equipment along with all the accessories out
of the reach of children and pets. Improper use could cause
suffocation and serious injury.

Extreme temperatures may cause the device to malfunction,
reduce the charging capacity and shorten the working life.

Please do not wet the device, for the liquid can cause
damage to the device. Remove any moisture.

Model: KBJ-103N-T8495-OTH FOWNES
FOWNES BROS & CO. INC
16 EAST 34TH ST.,
5TH FLOOR, NY, NEW YORK 10016

It will damage your hearing if you listen with high
volume for a long time. It is recommended that
only use the lowest volume which is necessary
for speaking and listening to music.

1. Guide

■ Headset introduction

USB Charging Cable:

Microphone

Power switch / Pairing
Play / Pause Audio
Receive / Hang up phone call

Charging Port

2.Instruction

■ Key Function - Place Earmuffs on head to hear prompts.

Power on
Pairing

Power off

Receive
Hang up
phone call

Play/Pause

3.Bluetooth Indicator Status

Some earmu models may not have any indicator lights.
If your model earmu is not equiped with indicator lights,
please see section 5 of this manual.

Work Status Indicator Light Status Remark

Pairing Mode

Connection

Phone call

Play Music

Press the button for 5 seconds to switch on and enter
into pairing mode (The bluetooth voice will indicate
“power on”, then it will indicate “pairing”. Once your
device is connected, it will indicate “paired”

Press the button for 3 seconds to switch off
(The bluettoth voice will indicate “power off” ).

When calls coming, press the button once to receive
phone calls, press again to hang up phone calls,
Press the button for 2 seconds to reject phone calls

In music mode, press the button once to pause, and
press it again to play. (when phone call comes, the
music will be off. When phone call is off, the music
will continue)

When the bluetooth is on, press the button twice

SIRI

this will activate the SIRI function

Switch on

Switch off

Red indicator flash once
Blue indicator flash once

Red indicator flash once

Red and blue indicators take

turns to flash

Blue indicator will flash once

every 6 seconds

Blue indicator will flash once

every 6 seconds

Blue indicator will flash once

every 6 seconds

Low battery
warning

Charging

Red indicator will flash once

every 60 seconds

Red indicator is on all the time when
charging; the light is off when charged full

4. SIRI :

The function applies to phone with siri and other

compatible voice recognition functions.

(1) Turn on the bluetooth function of the phone.
(2) Press button for 5 seconds to swith on and enters int o
pairing mode when the red and blue indic ators take turns
to flash.
(3) Find “Bluetooth Earwarmers” from the device list of the
phone and make connection.
(4) Press the key twice short ly to activate siri funct ion.
(5) Microphone on the phone will appear at that time, and you
can use siri directly.

音控制

Press the
button twice
shortly

5.Voice Prompt Function

VOICE PROMPT

Power on

Pairing

Your device is connected

Power off

Incoming call When there comes a call

Low battery

STATUS

When you turn the headphone o n

When entering into pairing mode

When connect the device successfully

When you turn the headphone off

Low battery warning

6.Headset Charging

This headset is equipped with built-in non-detachable and
rechargeable battery.
Please make sure that the battery is charged full for the first
time use.

■ Connect the charger to the charging port.

■ Insert the charger into a standard power outlet.

During charging, the indicator will turn Red.

■ After full charging, red indicator will turn off. Please unplug
the travel charger from the power outlet and headset.

■ Please do not dial or receive phone calls during charging.

■ When the battery is low, the headset will prompt and the red

indicator will flash.

7.Project Specification and Instruction

- Bluetooth Version : V4.1

- Supported devices: Bluetoot h mobile phones, Bluetooth
speakers Bluetooth P C and other Bluet ooth devices

- Maximum work range: 33 Feet (10 Meters)

- Talk time: About 15 Hours

- Music play: About 13 Hours

- Charging time: 2.5 Hours

- Charging Voltage: DC 5V

- Work Voltage: 3.7 V 250MAH

- Microphone Sensiti vity: 38±3dB

- Transmitter: Class 2

- Frequency Respons e: 20Hz~20KHz

※ The actual t ime may vary from mobile phone types and
functions.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help

Changes or modications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

Use the Bluetooth Earwarmer in the environment with the temperature between-10°C and
40°C, otherwise, it may damage your Bluetooth Earwarmer. It can be operating under
2000m.

Hereby, (FOWNES BROS & CO. INC) declare that the radio equipment type (Bluetooth
Earwarmer) is compliance with Directive 2014/53/EU.

For Battery: Risk of explosion battery is replaced by an incorrect type, dispose of used
batteries according to the instructions.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

The product supplied by build-in lithium battery, and charged from Micro-B USB port.
Antenna gain: 0dBi

Operating Frequency Range(s): 2402MHz~2480MHz The maximum RF Output Power:

0.30dBm

FCC ID: 2APAY-KBJ-103N

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TOT HE FOLLOWING TWO CONDITIONS: (1) THIS DEVICEMAY
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTEREFENCE THAT
MAY CAUSE UNDESIRED OPERATION.