Page 1
Instruction Sheet
STEPS:
1. (a,b) Let’s get your knobs turned around! Reverse the knobs with a Phillips head screwdriver. Unscrew each inwardfacing knob and reattach by screwing the knob onto the outside of the unit.
2. (a,b) To attach the legs, use a 7/16” wrench or ratchet and four bolts with washers. Lay the top of the piece upside
down on a cleared o, at surface. One leg at a time, line up the leg with the pre-drilled holes facing inward to the
corner bracket on the desk top. With a washer on each bolt, insert the bolt through the hole on corner bracket and
using the wrench or ratchet, screw the bolt into the predrilled hole on the leg. . Repeat for all four legs.
3. (a,b) Get your piece at the height that’s best for you by adjusting the levelers. If the levelers are too tight, use plyers
to loosen and then adjust by hand. Get the unit in its desired location. Next, adjust the levelers to line up the tops.
In order to increase the height, turn them counterclockwise. To lower the height, turn the levelers clockwise.
4. Care for your piece by dusting it with a slightly damp rag. Happy cleaning!
1
1a
1
2a
1b
2b
Hardware
Provided:
• Legs x4
• Levelers
• 2 “ Lag Bolts x4
• Washers x4
Tools
Needed:
• Phillips head
screwdriver
• Pliers
• ⁄” wrench or
ratchet
3a
3b
Loading...