Foundations EAKF1083 Installation & Assembly

INSTALLATION INSTRUCTIONS

The Ultra Changing Station Makes One Person

Installation Ultra Simple!

When selecting your installation location be aware of ADA guidelines if applicable. Specic ADA

compliant sections can be found listed in the changing station instructions

Before we begin, unseal the box and remove the contents. Enclosed is the Changing Station and

The EZ Mount Backer Plate, along with all of the screws, anchors, washers, and screw caps

needed for installation. Also included is a set of keys and a Liner Starter Kit, including a small

stack of liners, for the built-in liner dispenser.

2

Step One

First we will install the EZ Mount Backer Plate

onto the wall. The backer plate will be taped to

the back of the unit and looks similar to

a metal bar.

Using a studnder and pencil, mark the area

where the studs are on the wall.

Place the EZ Mount Backer Plate ush against

the wall where you’ve marked the studs and

make sure it is level.

Note that wood, metal, tile, and concrete block

walls have different installation instructions for

each type of wall. Use the instructions and

diagrams in the packet to determine

installation steps for your specic wall type

before drilling into the wall.

Step Two

Drill the holes into the areas on the wall

that you marked with the pencil using the

designated drill bit size. Depending on the

type of wall you have, you may need to

use an anchor.

3

Step Three

Line up the Mounting Bracket with the holes

you have drilled. You will be screwing the

Mounting Bracket into the wall using the

Mounting Screws that were included.

Step Four

Place the Screw into the Mounting Bracket and

align it with the holes you drilled into the wall.

Screw the Mounting Bracket into the wall.

Step Five

Next, hang the lip that’s located on the back

side of the Changing Station onto the

Mounting Bracket making sure that the

changing station is secure.

Now that the lip of the Changing Station is

securely resting on the Mounting Bracket, you

can open the Changing Station.

4

Step Six

Use a pencil to mark the holes in each corner

of the Changing Station. This marks where

you’ll be drilling holes into the wall for the

Changing Station. Take the unit off the bracket

and set it aside.

Step Seven

Drill the 4 holes into the wall on the areas

that you marked with pencil. Drill the holes

into the wall using the appropriate drill bit and

mounting hardware for your substrate. You

will now be able to put the changing station

back on the wall.

Step Eight

You will be using a combination of the washers,

screws, and anchors (if necessary) to screw the

changing station into the wall in the holes that

you have drilled.

5

Step Nine

Place each Washer on top of the hole you

drilled into the wall for each corner of the

Changing Station. Then place each Screw

through the washer and into the hole.

Screw the Changing Station into the wall.

Step Ten

Repeat this process for all 4 corners.

Step Eleven

Now it’s time to add the nishing touches for

an ULTRA sleek nish.

Grab the Screw Caps that were included

and place them over the holes to cover all

4 of the Screws.

Wow! Now that’s an

ULTRA sleek nish.

Questions or Comments?

Please contact Customer Service at

877.716.2757 (U.S. only) or 330.722.5033.

Monday-Friday 8:00-5:00 EST

6