Foundations 100-SSV, SI260D User Manual

Model 100-SSV

Stainless Steel Vertical Changing Station

Installation Instructions

Thank you for purchasing a quality Foundations®product. Our goal is 100% consumer satisfaction!

If, for any reason you are not satisfied or if you have questions regarding your product or installation,

please contact our customer service team at 1-877-716-2757. Please DO NOT contact your distributor

or reseller as we are better prepared to assist you.

WARNING

• Failure to follow these warnings and the installation instructions could result in serious injury
or death.

• Read all instructions before installing diaper changing station. Keep these instructions. DO NOT
discard.

SI260D

ADULT INSTALLATION REQUIRED.

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

ABC
Level (A)
Measuring tape (B)

ower drill (C)

P

EAD ALL INSTRUCTIONS BEFORE ASSEMBLY OF DIAPER CHANGING STATION

• R

• Unpack carton and identify all parts.

WARNING

This changer has six (6) recess mounting holes.

•

The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore,

•

MUST be firmly secured in order to support the weight they are intended to support. It is recommended that this unit be
installed in a recessed fashion. If surface mounting, contact an architect, building contractor, or Professional Engineer
for proper installation and hardware. Contact an architect or building contractor if any questions.
Child should never be left unattended.

•

Avoid serious injury from falling or sliding out. Always use restraint system.

•

Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total

•

weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to
exist.

PARTS LIST

Parts Description Quantity

Door / Wall Plate 1

IMPORTANT: Due to widely varied wall material,
anchoring to be determined by architect or engineer.

33-3/8

(848 mm)

20-3/4”

(527 mm)

(Door)

30-3/8”

(771 mm)

(R)

33-7/8”

(860 mm)

(SM)

A.D.A. Compliance:

4.4.1 Maximum Protruding Objects

4.2.5 Forward Reach

4.2.6 Parallel Approach

4.27.4 Operation
Compliant when properly installed.

Door / wall plate to be

mounted on outside of

restroom door.

OPERATION:

Rotate base downward. Place infant on top of the changing surface. Use restraint system as described below. After child has been
changed, remove restraint system and rotate base back up against the wall.

USE OF RESTRAINT SYSTEM:

Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap
in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock
the strap into place. Slide red locking tab over top of buckle (Fig. a). Reverse steps to loosen strap.

Top Of
Buckle

Locking

MAINTENANCE AND CLEANING:

Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts.
For replacement parts, contact customer service at 1-877-716-2757.

Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong
chemical cleaners or cleaning agents that may be hazardous to children.

Fig. a

1

Tab