Thank you very much for purchasing the Model 6301D.
Model 6301D is the digital personal monitor with 10W of internal power amplifier and is
equipped with the digital input terminal (XLR-3-31 type) as well as the analog input
terminal (PHONE). Furthermore, the digital through terminal (XLR-3-32 type) can be used
to connect multiple 6301D.
Fully read this manual before using the unit so that you can use the unit properly.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER - SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
"WARNING"
"TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE."
SAFETY INSTRUCTIONS
1. Read Instructions - All the safety and operating
instructions should be read before the appliance is
operated.
2. Retain Instructions - The safety and operating
instructions should be retained for future reference.
3. Heed Warnings - All warnings on the appliance and in
the operating instructions should be adhered to.
4. Follow Instructions - All operating and use instructions
should be followed.
5. Water and Moisture - The appliance should not be used
near water - for example, near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement, or near a
swimming pool, and the like.
6. Carts and Stands - The appliance should be used only
with a cart or stand that is recommended by the
manufacturer.
An appliance and cart combination should be moved with
care. Quick stops, excessive force, and uneven surfaces
may cause the appliance and cart combination to overturn.
7. Wall or Ceiling Mounting - The appliance should be mounted
to a wall or ceiling only as recommended by the
manufacturer.
8. Ventilation - The appliance should be situated so that its
location or position dose not interfere with its proper
ventilation. For example, the appliance should not be
situated on a bed, sofa, rug, or similar surface that may
block the ventilation openings; or, placed in a built-in
installation, such as a bookcase or cabinet that may impede
the flow of air through the ventilation openings.
9. Heat - The appliance should be situated away from heat
sources such as radiators, heat registers, stoves, or other
appliances (including amplifiers) that produce heat.
10. Power Sources - The appliance should be connected to a
power supply only of the type described in the operating
instructions or as marked on the appliance.
11. Grounding or Polarization - The precautions that should
be taken so that the grounding or polarization means of an
appliance is not defeated.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:
POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA
LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU
FOND.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated
“dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
12. Power Cord Protection - Power supply cords should be
routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience
receptacles, and the point where they exit from the
appliance.
13. Cleaning - The appliance should be cleaned only as
recommended by the manufacturer.
14. Nonuse Periods - The power cord of the appliance
should be unplugged from the outlet when left unused
for a long period of time.
15. Object and Liquid Entry - Care should be taken so that
objects do not fall and liquids are not spilled into the
enclosure through openings.
16. Damage Requiring Service - The appliance should be
serviced by qualified service personnel when:
A. The power supply cord or the plug has been
damaged; or
B. Objects have fallen, or liquid has been spilled into
the appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally
or exhibits a marked change in performance; or
E. The appliance has been dropped, or the enclosure
damaged.
17. Servicing - The user should not attempt to service the
appliance beyond that described in the operating
instructions. All other servicing should be referred to
qualified service personnel.
18. The appliance should be situated away from drops of
water or spray of water.
19. Objects containing liquid such as vase must not be put
on the appliance.
20. The appliance is not completely isolated from the power
supply even if the power switch is at off position.
21. Apparatus shall not be exposed to dripping or splashing
and no objects filled with liquids, such as vases, shall
be placed on the apparatus.
22. Only use attachments/accessories specified by the
manufacturer.
23. An appliance with a protective earth terminal should be
connected to a mains outlet with a protective earth
connection.
24. An appliance should be placed in a position where an
AC plug/inlet can be easily pulled out by hand.
2
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install
in accordance with the manufacturer's
instructions.
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug.
A polarized plug has two blades with one wider
than the other. A grounding type plug has two
blades and a third grounding prong. The wide
blade or the third prong are provided for your
safety. If the provided plug does not fit into
your outlet, consult an electrician for
replacement of the obsolete outlet.
11)Only use attachments/accessories specified
by the manufacturer.
12)Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13)Unplug this apparatus during lightning storms
or when unused for long periods of time.
14)Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
10)Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
3
Names and functions
Front
2
ON
OFF
1
VOLUMEPOWER
654
7
3
8
2
9
1
10
0
3
1)POWER switch
Turns on or off the unit main power.
1)POWER indicator
The power indicator is lit in RED when
6301D is turned on. When resolving
to an incoming digital signal, the LED
color changes to GREEN.
3)Output level control
Adjusts the output level of the internal
power amplifier.
4)AC IN connector
Connect to the AC outlet using the
supplied power cord.
Make sure that the AC outlet voltage
matches the unit.
5)[ANALOG IN] connector (phone jack)
Receives a -10dBV analog audio signal.
When a plug is inserted into this
terminal, the analog signal has a
priority over the digital signal fed to
the [DIGITAL IN] terminal.
Rear
ANALOG
INPUT SEL
IN
R+LR
L
6
5
AVIS:
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AC-IN
DIGITAL
THRUIN
POWER ON
POWER ON
RED
LOCKED
GREEN
CAUTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
7
8
4
7)[DIGITAL IN] connector (XLR-3-31 type)
This connector accepts an AES/EBU
digital signal at the sampling frequency
within the 44.1kHz to 96kHz range.
<CAUTION>:
into the [ANALOG IN] terminal, the
[DIGITAL IN] terminal is cut off.
Thus, no digital signal can be input.
8)[DIGITAL THRU] connector (XLR-3-32
type)
This connector echoes the digital signal
received at the [DIGITAL IN] connector.
1
When a plug is inserted
3
Pin 1
Pin 2
21
Pin 3
3
Pin 1
Pin 2
2
Pin 3
Ground
Hot (+)
Cold (-)
Ground
Hot (+)
Cold (-)
6)[INPUT] select switch
Switches the digital input signal
channel (L, L+R or R).
4
Main specifications
<Speaker section>
• Unit: 10 cm, cone type, magnetically shielded
type x 1
• Impedance: 4 ohms
• Output sound pressure level:84 dB/W (1m)
• Frequency response:80 Hz to 13 kHz
<Power amplifier section>
• Rated output power:10 W or more (4 ohms,
1 kHz)
• Residual noise: -60 dBV or less (DIN AUDIO)
• Distortion:0.5 % or less (10 W/4ohms, 1 kHz)
• Digital input
Connector:XLR-3-31 type (balanced)
Format:IEC 60958 (AES/EBU)
Sampling frequency: 44.1 kHz to 96 kHz
• Digital thru
Connector:XLR-3-32 type (balanced)
Format:IEC 60958 (AES/EBU)
• Analog input
Connector:1/4 phone jack (unbalanced)
Nominal input level: -10dBV
Input impedance: 10 kohms or more
<General>
• Dimensions: 120 (W) x 190 (H) x 120 (D) mm
• Weight: Approximately 2 kg
• Power requirement: 120VAC 50/60Hz
230VAC 50/60Hz
240VAC 50/60Hz
• Power consumption:6W
• Supplied accessories: Power cord, Owner's
manual
• Optional accessories:Model 9610 mounting
bracket (see below.)
6301D
190
POWER
VOLUME
ON
OFF
120
120
9610
* Specifications and appearance are subject to change without notice for product improvement.
5
Declaration of EC Directive
This equipment is compatible with the EMC Directive (89/336/EEC) - Directive on approximation of member
nation's ordinance concerning the electromagnetic compatibility and with the Low Voltage Directive (73/23/
EEC) - Directive on approximation of member nation's ordinance concerning electric equipment designed to
be used within the specified voltage range.
The Affect of Immunity on This Equipment
The affect of the European Specification EN61000-6-1 (coexistence of electromagnetic waves - common immunity
specification) on this equipment are as shown below.
In the electrical fast transient/burst requirements, surge, conducted disturbances by radio-frequency fields, power frequency
magnetic field, radiate electromagnetic field requirements and static electricity discharging environment, this could be
affected by generation of noise in some cases.
FOSTEX DISTRIBUTORS LIST IN EUROPE
* Including non-EU countries (as of January, 2005)
<AUSTRIA>
NAME: ATEC Audio-u. Videogeraete VertriebsgesmbH.
ADD: Im Winkel 5, A-2325 Velm, Austria
TEL: (+43) 2234-74004, FAX: (+43) 2234-74074
<BELGIUM>
NAME: General Audio
ADD: Raymond Pelgrimslaan 101, B-1702 GrootBijgaarden, Belgium
TEL: (+32) 2-4630650, FAX: (+32) 2-4661500
NAME: Caius - Tecnologias Audio e Musica, Lda.
ADD: Praca do Bom Sucesso, No 61 Bom Sucesso Trade
Center, Escritorio 701/702, 4150 - 146 Porto, Portugal
TEL: (+351) 22-608-06-10, FAX: (+351) 22-608-06-29
<SPAIN>
NAME: Letusa S. A.
ADD: C/Laguna 10, 28923 Alcorcon, Madrid, Spain
TEL: (+34) 91-4862800, 91-4470898
FAX: (+34) 91-6414597
<SWEDEN>
NAME: Sennheiser AB
ADD: John Ericssonsgatan 10, P.O. Box 22035, SE-104 22
Stockholm, Sweden
TEL: (+46) 8 566 16400, FAX: (+46) 8 566 16490
<SWITZERLAND>
NAME: Audio Bauer Pro AG
ADD: Bernerstrasse-Nord 182, CH-8064 Zurich,
Switzerland
TEL: (+41) 1-4323230, FAX: (+41) 1-4326558
<UK>
NAME: SCV London
ADD: 40 Chigwell Lane, Oakwood Hill Industrial Estate,
Loughton, Essex IG10 3NY U. K.
TEL: (+44) 20-8418-0778, FAX: (+44) 20-8418-0624
6
FOSTEX CO.
3-2-35, Musashino, Akishima-shi, Tokyo, Japan, 196-0021