SUMMITTM BIKE RACK
SURFACE MOUNT INSTALLATION INSTRUCTIONS
MATERIALS INCLUDED
epoxy
STEP BY STEP
FOR ALL SURFACE MOUNTED SUMMIT BIKE RACKS
7/32" hex bit for
tamper-resistant
screws
a b
TOOLS NEEDED
pencil
c
1/4", 1/2" & 3/4" drill
bits for concrete
hammer drill
epoxy gun
steel
wire brush
Loctite
a
Mark hole locations
• Place bike rack in desired location. Mark
center of each hole location with a
pencil.
Drill holes
• Use hammer drill to drill 4.5" deep x 3/4"
diameter anchor hole at each marked
location using a 3/4" drill bit suitable for
concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 1/4" diameter drill
bit followed by 1/2" and nally 3/4" for
maximum accuracy.
Fill holes & insert anchors
• Use compressed air and steel wire brush
to clean each anchor hole in accordance
with epoxy instructions.
• Use epoxy in epoxy gun to ll each anchor
hole 5/8 of the hole depth in accordance
with epoxy instructions.
• Insert 3/8"-16 x 4-1/4" epoxy anchor
(a) into each anchor hole so anchor top
is ush with ground. Allow proper curing
time according to cure schedule on epoxy
instructions before moving on to Step 4.
T 800.451.0410 | www.forms-surfaces.com
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 1 of 3 | Rev. 05-19-14
SUMMITTM BIKE RACK
SURFACE MOUNT INSTALLATION INSTRUCTIONS
STEP BY STEP
FOR ALL SURFACE MOUNTED SUMMIT BIKE RACKS
b
c
Position bike rack
• Position bike rack so that mounting
holes line up with anchors.
T 800.451.0410 | www.forms-surfaces.com
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
Attach bike rack
• Insert four 3/8"-16 x 1-1/4" hex head
cap screws (b) into mounting holes in
bike rack.
Attach base plate & tighten screws
• Slide base plate over bike rack.
• Thread two 3/8"-16 x 1" pin-in-hex
button at head screws (c) through each
hole using 7/32" hex bit for tamperresistant screws.
• Tighten all screws.
NOTE: Forms+Surfaces recommends
applying Loctite® or similar threadlocking adhesive.
page 2 of 3 | Rev. 05-19-14
SUMMITTM BIKE RACK
wall
SURFACE MOUNT INSTALLATION INSTRUCTIONS
RECOMMENDED BICYCLE RACK SPACING PER ASSOCIATION OF PEDESTRIAN AND BICYCLE PROFESSIONALS (APBP) GUIDELINES FOR ALL SUMMIT BIKE RACKS
wall
36" min
36"
(24" min)
SUMMIT BIKE RACK
96" (72" min) 60" (48" min) 96" (72" min)
48" min
36" min
wall
wall
T 800.451.0410 | www.forms-surfaces.com
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 3 of 3 | Rev. 05-19-14
Loading...