Food Warming Equipment SRF Owner’s Manual

OPERATING

INSTRUCTIONS

COLD / FREEZE CONVERTIBLE

RF SERIES SRF SERIES URFS SERIES

USE AS MOBILE REFRIGERATOR OR FREEZER

FWE MOBILE COLD / FREEZE CONVERTIBLE SERIES

Either a

Refrigerator

or a

Freezer

all in one unit!

Ultimate foodservice

flexibility – change cabinet

from refrigerated mode

to freezer mode as

your food service holding

needs change.

CONGRATULATIONS...

...and thank you for purchasing an FWE Mobile COLD / FREEZE
Convertible cabinet. Your unit has been designed and manufactured
under rigid controls to assure you the most efficient service. It is a
full time unit, and may be used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your
cabinet will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to put warranty into effect.

2 FWE COLD / FREEZE CONVERTIBLE: USE AS MOBILE REFRIGERATOR OR FREEZER

FWE MOBILE COLD / FREEZE CONVERTIBLE SERIES

INSTALLATION

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the unit. The serial tag is located by the electrical cord.
Please record them on the back of this booklet. When ordering
parts and/or service, you will need to provide this information.
The voltage and amperage of the unit are also stamped on the
serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place
during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE standard models operate on 110/120 volt, 60 Hz, 1 ph, A.C.
(unless ordered otherwise), and are equipped with a three prong
grounding cord plug for your protection against possible shock
hazards. Be sure to plug only into a properly grounded three
prong wall receptacle. If you have any questions with regard to
adequate wiring or grounding in your building, a qualified
electrician should be contacted before using your cabinet.
The amperage of your cabinet is stamped on the name plate
attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3

GENERAL OPERATING INSTRUCTIONS

OPERATING THE CABINET

1) PLUG CABINET INTO A PROPERLY GROUNDED POWER
RECEPTACLE. Press ON/OFF Icon to “ON” position. The red

indicating light will come on and remain on until power button
is pressed to “OFF”, or the unit is unplugged.

2) SELECT MODE: PRESS AND HOLD 5 seconds the desired
mode button. Indicator light will confirm selected mode.

REFRIGERATOR MODE:

Temperature Range: 33°F to 41°F (1°C to 5°C)

FREEZER MODE:

Temperature Range: 5°F to 32°F (-15°C to 0°C)

3) SELECT A TEMPERATURE SETTING.

Pre-Set at 35°F for REFRIGERATOR:

Temperature Range: 33°F to 41°F (1°C to 5°C)

Pre-Set at 15°F for FREEZER:

Temperature Range: 5°F to 32°F (-15°C to 0°C)

Press ▲ to raise the temperature of the cabinet and scroll to
desired temperature. Press ▼ to lower the temperature of the
cabinet and scroll to desired temperature.

4) PRE-CONDITION CABINET FOR 30-60 MINUTES.
Your cabinet should be pre-cooled 30-60 minutes before loading
at your desired set temperature.

AVOID PUTTING HOT FOODS INTO A COLD CABINET!

5) LOADING THE CABINET - During the loading procedure, keep

the doors closed as much as possible. After loading is completed,
do not open doors again until you are ready to serve.

6) TRANSPORTING FOODS - Your cabinet is equipped with a
positive transportation latch to assure safety during transportation.
After loading the cabinet, keep it plugged in with the door closed
and wait 15 - 20 minutes before moving it, to allow it to reach
maximum holding temperature. Then wheel to serving area, and
plug the cabinet into an electrical outlet at the serving location
(if available), so that the compressor will re-activate and
automatically hold at the pre-selected temperature.

4 FWE COLD / FREEZE CONVERTIBLE: USE AS MOBILE REFRIGERATOR OR FREEZER