Food Warming Equipment PTS-60-8HA Installation Manual

OPERATING

INSTRUCTIONS

CORRECTIONAL CABINETS

Prisoner Tray Servers

Catalog Items and
Custom Variations of the
“PTS” and “PTST” Model
Number Series

Also HDM Items
Heavy-Duty Modified

Variations of the
HDM Model
Number Series

FWE MOBILE CORRECTIONAL CABINETS

Heated Compartment Ambient Compartment

PTST-141064H-182615A

CONGRATULATIONS...

...and thank you for purchasing an FWE Correctional serving cabinet.
Your unit has been designed and manufactured under rigid controls to
assure you the most efficient service. It is a full time unit, and may be
used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your
cabinet will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

1 FWE PRISONER TRAY DELIVERY CABINETS FOR CORRECTIONAL FACILITIES

FWE MOBILE CORRECTIONAL CABINETS

CONTROL PANEL OVERVIEW

Easy to Use Controls

Control Panel
Component
Identification:

Upfront ON / OFF switch

Operational range
thermometer

The POWER and CYCLING
indicator lights are mounted
horizontally on PTS Models
and vertically on PTST models.

“POWER ON”
indicator light
(green)

“CYCLING ON”
Indicator light
for heat cycling

Adjustable
thermostat with
retention strap

- OR -

HIDDEN

CONTROLS

(Optional)

The thermostat

is pre-set to 170°F

or to a temperature

setting specified at

the time of order.
The thermometer
is the only visible

component.

With all stainless steel, fully welded equipment, built to withstand the every
day rigor of rough handling and constant use and abuse, assuring years of
dependable service. FWE mobile equipment is counted on every day to serve
thousands of inmates, performing under the toughest conditions, day in and
day out. From the initial design, all the way through the manufacturing
process, every piece of FWE equipment must meet rigorous quality control
standards.

2

FWE MOBILE CORRECTIONAL CABINETS

INSTALLATION AND WARNINGS

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the lower back of the unit. Please record them in this booklet,
in the space provided on page 9. When ordering parts and/or
service, you will need to provide this information. The voltage
and amperage of the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place
during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE models operate on 110/120 volt, 60 Hz, 1 ph, A.C.
(unless ordered otherwise), and are equipped with a three
prong grounding cord plug for your protection against possible
shock hazards. Be sure to plug only into a properly grounded
three prong wall receptacle. If you have any questions with
regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your
cabinet. The amperage of your cabinet is stamped on the
name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3 FWE PRISONER TRAY DELIVERY CABINETS FOR CORRECTIONAL FACILITIES