Food Warming Equipment PTS-0709-135-B Service Manual

OPERATING

INSTRUCTIONS

PTS BACK HEAT BOX

TM

Prisoner Tray Server with

Removable Back Heat Box Module

FWE PTS SERVER BACK HEAT BOX

PTS-0709-135-B

CONGRATULATIONS...

...and thank you for purchasing an FWE PTS with Removable Back
Heat Box Module.Your unit has been designed and manufactured
under rigid controls to assure you the most efficient service.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
and heat module will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

2

FWE PTS SERVER BACK HEAT BOX

Heat Box

Security

Lock

Power

Indicator

Light

ON / OFF

Switch

Handle

Grip

3

FWE PTS SERVER BACK HEAT BOX

INSTALLATION AND CARE

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the back of the unit. Please record them in this booklet, in the
space provided. When ordering parts and/or service, you will
need to provide this information. The voltage and amperage of
the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE Removable Back Heat Module or models operate on
120 volt or 220-240 volt, 60 Hz, 1 ph, A.C. (unless ordered
otherwise), and are equipped with a three prong grounding
cord plug for your protection against possible shock hazards.
Be sure to plug only into a properly grounded three prong wall
receptacle. If you have any questions with regard to adequate
wiring or grounding in your building, a qualified electrician should
be contacted before using your cabinet. The amperage of your
heat module is stamped on the name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

4