Food Warming Equipment PH-1826-14 Installation Manual

OPERATING

INSTRUCTIONS

PROOFER/HEATER CABINETS

PHU SERIES

PH-1826 SERIES

PH-BBC SERIES

ETC-1826-PH SERIES

ETC-UA-PH SERIES

Heat Basin Water Pan

Thermometer

Air Temperature “HEAT” Control Dial

Air Temperature Cycling Light
Air Moisture Cycling Light

Air Moisture “PROOF”
Control Dial with “P” to
Indicate Proof Position

Main Power Switch

PROOFER/HEATER CABINETS

Proof, Heat and Hold -

all in the same versatile cabinet!

Serial Tag

and

Parts List

Control

Panel

Uprights and

tray slides

remove and
adjust easily
without tools

Heat System

Tunnel

1 FWE PROOFER/HEATER

12" x 20" Water Pan

and Heat Basin

Moisture

Drip Trough

With

Removable

Drain Plug

FWE PROOFER/HEATER CABINETS

REGISTRATION CARD

CONGRATULATIONS...

...and thank you for purchasing an FWE Mobile PROOFER/HEATER
cabinet. Your unit has been designed and manufactured under rigid
controls to assure you the most efficient service. It is a full time unit,
and may be used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to put warranty into effect.

IMPORTANT: Your FWE Proofer-Heater is designed to give

maximum performance by using the heat control and the

proof control simultaneously

. To achieve the desired results

for various products, it is suggested that you experiment

with various settings.

Please see the GENERAL OPERATING INSTRUCTIONS -

PROOF MODE for several examples of simultaneous

control settings, resulting in relative humidity.

CAUTION: HOLDING FOOD AT TEMPERATURES

OF LESS THAN 140°F MAY BE DANGEROUS.

TEMPERATURES UNDER 140°F PROMOTE THE GROWTH

OF HARMFUL BACTERIA AND TOXINS IN SOME FOODS.

2

PROOFER/HEATER CABINET

INSTALLATION

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the lower back of the unit. Please record them in this booklet,
in the space provided on page 9. When ordering parts and/or
service, you will need to provide this information. The voltage
and amperage of the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place
during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE Proofer/Heater models operate on 110/120 volt,
60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped
with a three prong grounding cord plug for your protection
against possible shock hazards. Be sure to plug only into a
properly grounded three prong wall receptacle. If you have any
questions with regard to adequate wiring or grounding in your
building, a qualified electrician should be contacted before using
your cabinet. The amperage of your cabinet is stamped on the
name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3 FWE PROOFER/HEATER