Food Warming Equipment MT-1826-18PDD Installation Manual

OPERATING

INSTRUCTIONS

MOISTURE-TEMP CABINETS

Heat Cycling Light

Thermometer

Air Temperature
“HEAT” Control Dial

Air Moisture Control

Main Power Switch

MOISTURE-TEMP CABINETS

Serial Tag

and

Parts List

Control

Panel

Heat System

Tunnel

1 FWE MOISTURE-TEMP HEAT SYSTEM

12" x 20" Water Pan

and Heat Basin

Moisture

Drip Trough

With

Removable

Drain Plug

FWE MOISTURE-TEMP CABINETS

COMPLETE AND RETURN YOUR WARRANTY CARD

CONGRATULATIONS

...and thank you for purchasing an FWE MOISTURE-TEMP cabinet.
Your unit has been designed and manufactured under
rigid controls to assure you the most efficient service.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine
of proper use and care described on the following pages, your
cabinet will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to put warranty
into effect.

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
near the rear of the unit. Please record them in this booklet,
in the space provided When ordering parts and/or service, you
will need to provide this information. The voltage and amperage
of the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding which
held all doors, shelves, racks, cord, etc., in place during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

The amperage of your cabinet is stamped on the name plate
serial tag attached to the unit. FWE models are equipped with
a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your cabinet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD ATTEMPT
TO REPAIR OR REPLACE ELECTRICAL COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

2

FWE MOISTURE-TEMP CABINETS

CONTROL PANEL

EASY-TO-USE CONTROLS

Heat Cycling Light

Press tactile key

to alternate

between

ACTUAL temp

(with ACTUAL LED

illuminated)

and SETPOINT

temperature

Thermometer

Air Temperature
“HEAT” Control Dial

3 FWE MOISTURE-TEMP HEAT SYSTEM

Air Moisture Control Dial

“P” to Indicates Proof Position

Proof Cycling Light

Main Power Switch