Food Warming Equipment HMC-230 Operators Manual

OPERATING

INSTRUCTIONS

CHIP WARMER

“HMC” SERIES

FWE CHIP WARMER

Stainless Steel Construction

with Easy-To-Clean Interior

Remove

Bracket

for thorough

cleaning

Perforated feeder

panels protect chips

for burning

Drop-down

hopper

Slide-Out Crumb Pan

is removable

CONGRATULATIONS...

...and thank you for purchasing an FWE Chip Warmer. Your unit has
been designed and manufactured under rigid controls to assure you
the most efficient service. It is a full time unit, and may be used
continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

2

FWE CHIP WARMER

INSTALLATION AND CARE

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the side of the unit. Please record them in this booklet, in the
space provided on the back page. When ordering parts and/or
service, you will need to provide this information.
The voltage and amperage of the unit are also stamped
on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place during
shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

The amperage of your cabinet is stamped on the serial tag
attached to the unit. FWE standard models are equipped with
a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building,
a qualified electrician should be contacted before using
your cabinet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3