Food Warming Equipment HLC SIDE LOAD Owner’s Manual

OPERATING

INSTRUCTIONS

HLC WITH DIXELL CONTROLS

Quick Start

On Page 4

Detailed

Operating Manual

for Controller

Included

Separately

HEATED HOLDING CABINET

“HLC” SERIES

WITH RADIANT HEAT SYSTEM

FWE HLC WITH DIXELL CONTROLS

Under-Counter, Counter-Top, Built-In

HEATED HOLDING CABINET

TEMPERATURE

CONTROLLER

MAIN POWER

SWITCH WITH

INDICATOR

LIGHT

1 FWE RADIANT HEAT SYSTEM

HLC-SL1826-5L

Shown with optional accessories

Lexan Door and

Dixell Temperature Controller

FWE HLC WITH DIXELL CONTROLS

INSTALLATION

CONGRATULATIONS...

...and thank you for purchasing an FWE Handy Line Compartment.
Your unit has been designed and manufactured under rigid controls
to assure you the most efficient service. It is a full time unit,
and may be used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the lower back of the unit. Please record them in this booklet,
in the space provided on page 9. When ordering parts and/or
service, you will need to provide this information. The voltage
and amperage of the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place during
shipment.

2

FWE HLC WITH DIXELL CONTROLS

WARNINGS

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE standard models operate on 110/120 volt, 60 Hz, 1 ph, A.C.
(unless ordered otherwise), and are equipped with a three prong
grounding cord plug for your protection against possible shock
hazards. Be sure to plug only into a properly grounded three
prong wall receptacle. If you have any questions with regard to
adequate wiring or grounding in your building, a qualified
electrician should be contacted before using your cabinet.
The amperage of your cabinet is stamped on the name plate
attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3 FWE RADIANT HEAT SYSTEM