Food Warming Equipment HHS-513-2039 Operator’s Manual
OPERATING
INSTRUCTIONS
HEATED HOLDING SHELVES
RADIANT “HHS” SERIES
HEATED HOLDING SHELVES
WITH DIXELL CONTROLS
RADIANT “HHS” SERIES
HHS-513-1839 MODEL SHOWN
TEMPERATURE
CONTROLLER
MAIN POWER SWITCH
WITH INDICATOR LIGHT
1 FWE RADIANT HEAT SYSTEM WITH DIXELL CONTROLS FOR “HHS” SERIES
HEATED HOLDING SHELVES
INSTALLATION
CONGRATULATIONS...
... and Thank You for purchasing an FWE Heated Holding
Shelf. Your unit has been designed and manufactured under
rigid controls to assure you the most ecient service. It is a full
time unit, and may be used continuously.
Please take a moment to read through this booklet of import-
ant information pertaining to your unit. By following a routine
of proper use and care described on the following pages, your
unit will last for many years.
IMPORTANT: Your Manufacturer Registration Card must
be returned within 30 days after initial delivery to activate the
warranty.
SERIAL AND MODEL NUMBER
These numbers are found on the nameplate (serial tag) axed
to the back of the unit. Please record them in this booklet, in
the space provided on page #. When ordering parts and/or
service, you will need to provide this information. The voltage
and amperage of the unit are also stamped on the serial tag.
UNPACKING
After uncrating your unit, remove all tape and padding which
held any moving parts in place during shipment.
2
HEATED HOLDING SHELVES
WARNINGS
ELECTRICIAL REQUIREMENTS AND GROUNDING
FWE standard models operate on 110/120 volt, 60 Hz, 1 ph, A.C.
(unless ordered otherwise), and are equipped with a three prong
grounding cord plug for your protection against possible chock hazards.
Be sure to plug only into a properly grounded three prong wall receptacle. If you have any questions with regard to adequate wiring or grounding in your building, a qualified electrician should be contacted before
using your unit. The amperage of your unit is stamped on the name
plate attached to the back of the model.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
3 FWE RADIANT HEAT SYSTEM WITH DIXELL CONTROLS FOR “HHS” SERIES
Loading...