Food Warming Equipment HDC-252-I Operator’s Manual

OPERATING

INSTRUCTIONS

MOBILE HEATED DISH CABINET

TM

“HDC” Series

FWE MOBILE HEATED DISH CABINETS

Stores, heats, and holds dishes.

HDC-252-I

Heated model shown with flip

back top opened.

CONGRATULATIONS...

...and thank you for purchasing an FWE Mobile heated dish cabinet.
Your unit has been designed and manufactured under rigid controls to
assure you the most efficient service. It is a full time unit, and may be
used continuously.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

1 FWE MOBILE HEATED DISH CABINET

FWE MOBILE HEATED DISH CABINETS

INSTALLATION AND WARNINGS

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the back of the unit. Please record them in this booklet, in the
space provided on the back page. When ordering parts and/or
service, you will need to provide this information. The voltage
and amperage of the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place during
shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE Heated Dish Cabinet models operate on 110/120 volt,
60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped
with a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building,
a qualified electrician should be contacted before using your
cabinet. The amperage of your cabinet is stamped on the
name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

2