Food Warming Equipment ETC-PH Operator’s Manual

OPERATING

INSTRUCTIONS

REMOVABLE PROOFER/HEATER

ETC-PH Series

Enclosed Transport Cabinet with

Removable Proofer/Heater Module

FWE ENCLOSED TRANSPORT CABINET

ETC Cabinet with Removable Proofer/Heater

CONGRATULATIONS...

...and thank you for purchasing an FWE Enclosed Transport Cabinet
with Removable Proofer/Heater Module. Your unit has been designed
and manufactured under rigid controls to assure you the
most efficient service.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
and heat module will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

1 FWE REMOVABLE PROOFER / HEATER

FWE REMOVABLE PROOFER/HEATER

Can be used with or without water.

Removable water pan

secured by handle strap(s)

Cord
Winding
Bracket

Heat

Control

Thermometer

Main Power

On/Off Switch

Proofer

Humidity

Control

2

ETC CABINET REMOVABLE PROOFER/HEATER

INSTALLATION AND CARE

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the unit. Please record them in this booklet in the space
provided. When ordering parts and/or service, you will need to
provide this information. The voltage and amperage of the unit
are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE Removable Proofer/Heater Module or models operate on
120 volt, 60 Hz, 1 ph, A.C. (unless ordered otherwise), and are
equipped with a three prong grounding cord plug for your
protection against possible shock hazards. Be sure to plug only
into a properly grounded three prong wall receptacle. If you have
any questions with regard to adequate wiring or grounding in
your building, a qualified electrician should be contacted before
using your cabinet. The amperage of your heat module is
stamped on the name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

3 FWE REMOVABLE PROOFER / HEATER