Food Warming Equipment ETC-HD Service Manual

OPERATING

INSTRUCTIONS

REMOVABLE HEAT MODULE

ETC-HD Series

Enclosed Transport Cabinet with

Removable Heat Module

FWE ENCLOSED TRANSPORT CABINET

ETC Cabinet with Removable Heat Module

CONGRATULATIONS...

...and thank you for purchasing an FWE Enclosed Transport Cabinet
with Removable Heat Module. Your unit has been designed and
manufactured under rigid controls to assure you the
most efficient service.

Please take a moment to read through this booklet of important
information pertaining to your cabinet. By following a routine of
proper use and care described on the following pages, your cabinet
and heat module will last for many years.

IMPORTANT: Your Manufacturer Registration Card must be
returned within 30 days after initial delivery to activate the warranty.

2

FWE REMOVABLE HEAT MODULE

Can be used with or without water.

With removable water pan

secured by strap that doubles as handle

Heat

Control

Thermometer

Main

Power
On/Off
Switch

Cord

Winding

Brackets

3

FWE ETC CABINET WITH REMOVABLE HEAT MODULE

INSTALLATION AND CARE

SERIAL AND MODEL NUMBER

These numbers are found on the nameplate (serial tag) affixed
to the back of the unit. Please record them in this booklet, in the
space provided. When ordering parts and/or service, you will
need to provide this information. The voltage and amperage of
the unit are also stamped on the serial tag.

UNPACKING

After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.

ELECTRICAL REQUIREMENTS AND GROUNDING

FWE Removable Heat Module or models operate on 120 volt,
60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped
with a three prong grounding cord plug for your protection against
possible shock hazards. Be sure to plug only into a properly
grounded three prong wall receptacle. If you have any questions
with regard to adequate wiring or grounding in your building, a
qualified electrician should be contacted before using your
cabinet. The amperage of your heat module is stamped on the
name plate attached to the unit.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.

WARNING: ONLY A QUALIFIED ELECTRICIAN SHOULD

ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.

BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.

4