Food Warming Equipment BT Installation Manual
OPERATING
INSTRUCTIONS
ORIGINAL INSTRUCTIONS
TOP MOUNT HEAT SYSTEMS
INTERNATIONAL/DOMESTIC
UHST SERIES
TST SERIES
PST SERIES
BT SERIES
Caution: Read the
instructions before
using the machine.
FWE TOP MOUNT HEATED HOLDING CABINETS
WARNING SYMBOLS
WARNING SYMBOLS*
To indicate hazards arising from dangerous
voltages
To identify the terminals which, when connected
together, bring the various parts of an equipment or of a
system to the same potential.
To identify the terminal which is intended for
connection to an external conductor for protection against
electric shock in case of a fault, or the terminal of a protective earth (ground) electrode
To indicate that the marked item can be hot and should not
be touched without taking care
To indicate the “ON” condition for a part of
equipment
To indicate the “OFF” condition for a part of
equipment
To indicate the stand-by or preparatory state for a part of
equipment
To indicate maximum ll level
To indicate minimum water level
2 FWE TOP MOUNT HEAT SYSTEM
*SYMBOLS MAY VARY FROM UNIT TO UNIT
FWE TOP MOUNT HEATED HOLDING CABINETS
INSTALLATION
SEE SHIPPING LABEL FOR CASTER SIZE
CASTER DESCRIPTION
2” GREY RUBBER CASTER,SWIVEL W/BRK
CASTER 2” RIGID
CASTER 3” RIGID
CASTER 3.5” RIGID HEAVY DUTY
CASTER 4X2” EZ ROLL RIGID POLYBLUE
CASTER 5” RIGID HEAVY DUTY
CASTER 5” RIGID SUPER DUTY
CASTER 5” SWIVEL BRAKE RB GRS FIT Poly
CASTER 5” RIGID EZ ROLL POLY
CASTER 5” SWIVEL BRAKE EZ ROLL POLY
CASTER 6” RIGID HEAVY DUTY
CASTER 6” RIGID SUPER DUTY
CASTER 6” SWIVEL BRAKE EZ ROLL POLY
CASTER 6” RIGID EZ ROLL POLY
CASTER 8” PNEUMATIC RIGID
CASTER 8” RIGID HEAVY DUTY
CASTER 8” RIGID SUPER DUTY
CASTER 8” SWIVEL BRAKE EZ ROLL POLY
CASTER 8” RIGID EZ ROLL POLY
MAX WEIGHT
34Kg
68Kg
68Kg
113Kg
272Kg
124Kg
226Kg
340Kg
362Kg
362Kg
158Kg
272Kg
453Kg
453Kg
113Kg
226Kg
272Kg
544Kg
544Kg
Improper use of this machine can result in injury and/or death.
A schedule should be put in place for inspections and
preventative maintenance.
New users should be properly trained in the use of this
equipment.
No special protective equipment is required to operate
this unit.
Unplug unit before servicing.
IN THE EVENT OF ACCIDENT OR
BREAKDOWN - UNPLUG UNIT.
FOR SERVICE INQUIRIES PLEASE CALL
FWE SERVICE - 800-222-4393
3
FWE TOP MOUNT HEATED HOLDING CABINETS
WARNING AND CLEANING CARE
CLEANING
Keep your cabinet clean by simply wiping the interior and
exterior, as needed, with a damp cloth or sponge and a mild
soapy solution.
NEVER USE ABRASIVES, ACIDS, OR STRONG
CLEANERS.
Do not flood or allow electrical parts to become wet. The
interior tray slide assemblies and humidifier pans are
removable for easy cleaning.
A stainless steel cleaner/polish is recommended for the
exterior to maintain a “like-new” appearance.
DO NOT USE WAX OR STRONG CLEANERS ON DOOR
GASKETS OR VINYL TRIM.
4 FWE TOP MOUNT HEAT SYSTEM
FWE TOP MOUNT HEATED HOLDING CABINETS
REQUIREMENTS
ELECTRICAL REQUIREMENTS AND GROUNDING
For U.S. and Canada Models:
The amperage of your cabinet is stamped on the name plate
serial tag attached to the unit. FWE models are equipped with
a grounded cord plug for your protection against possible shock
hazards. Be sure to plug only into a properly grounded wall
receptacle. If you have any questions with regard to adequate
wiring or grounding in your building, a qualified electrician should
be contacted before using your cabinet.
For International Models:
May be shipped with no cord or plug.
Contact qualified service personnel for cord and plug installation.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE
CORD PLUG.
WARNING: ONLY QUALIFIED SERVICE PERSONNEL
SHOULD REMOVE, REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING
CONTROL PANEL, MOVING, CLEANING, OR SERVICING
UNIT.
INTENDED USE AND REQUIREMENTS
This unit is to be used for warming only.
Unit must be installed level.
5
Loading...