Follett VU155N User Manual
Vision™ ice and water dispensers
VU155N
Series
VU155N series – 115/60/1
VU155N0RP – Right hand tower, push-button actuation
VU155N0RL – Right hand tower, sanitary lever actuation
VU155N0LP – Left hand tower, push-button actuation
VU155N0LL – Left hand tower, sanitary lever actuation
CVU155N series – 220/60/1
CVU155N0RP – Right hand tower, push-button actuation
CVU155N0RL – Right hand tower, sanitary lever actuation
CVU155N0LP – Left hand tower, push-button actuation
CVU155N0LL – Left hand tower, sanitary lever actuation
High-capacity ice and chilled water dispensers with undercounter
ice storage. Up to 150 lbs (68kg) of ice storage. Standard
equipment includes 6" to 9" (153 to 229mm) adjustable legs for
undercounter dispenser support. Dispensers are auto-fill ready to
accept (2) Follett Satellite-fill
or slide-in installations.
_____________________________________________________
™
Chewblet
®
icemakers, for drop-in
Attractive, low-profile design
• Compact dispenser with undercounter storage extends
only 22" (559mm) above counter
• 12" (305mm) wide tower dispenses both ice and
chilled water
• Allows use in islands without restricting visibility
• Contemporary graphics and neutral colors blend into
any decor
• Fits into ADA-compliant 34" (864mm) counter
Faster, safer loading of ice at waist height
• Safe, easy waist-height loading from front or rear
• Eliminates overhead lifting of buckets or loading from ladders
• Allows quick reloading during serving period with
minimum disruption
Added flexibility to meet varied needs
• Reliably dispenses Follett’s Chewblet ice and most cubelet
ice up to 1" (26mm) square
• Choice of push-button or lever ice and water actuation
VU155N shown with left hand tower and push-button actuation
Pre-configured for Follett Satellite-fill Chewblet
icemakers
• Add one or two icemakers for added labor savings
and sanitation
• Consumer-preferred, chewable compressed nugget ice
• Slow melting, maintains drink temperature
Accessories
• Ice Manager integration kit (item# VUIMDVKIT)
801 Church Lane • Easton, PA 18040, USA
Toll free (800) 523-9361 • (610) 252-7301
Fax (610) 250-0696 • www.follettice.com
115V only
115V only
© Follett Corporation
Form #2790
VU155N
Series
Vision™ ice and water dispensers
Left Side
(696mm)
12" (305mm)
3/4 PVC
3.5"
(889mm)
25.8"
(656mm)
18.5"
(470mm)
air break*
power
bin signal
Refer to Design Detail Sheets for important
icemaker and installation information
Icemaker series Literature form#
MCD400 2810
HCC1000 3105
HCD1000 3110
HCC1400 3175
HCD1400 3110
drain pan
drain
3/8 water inlet
3/4 PVC
slip joint
drain
6"
(153mm)
23.50"
(597mm)
Front View – Right hand ice and water chutes
(shown with two HCC1000AVS Satellite-fill Chewblet icemakers)
12"
(305mm)
31.25"
(794mm)
air break*
electrical
connections
*DO NOT CONNECT
DRAIN SYSTEM
26.63"
(677mm)
1" min.
(26mm)
counter top
3/4"
PVC
slip
joint
drain
12" min.
(305mm)
Plug Configuration
(115V only)
NEMA 5-15
21.75"
(553mm)
49.75"
(1264mm)
28"
(712mm)
AIR BREAK TO
Connections/Installation
• Support all dispensers from below on channels or with supplied leg accessory
• Removable counter panel required for access to dispenser side opposite ice chute
• 3/4" PVC pipe nipple for bin drain and drain pan drain, 1" ID hose for beverage bath drain (do not tie drains together)
• Drawings show units with right hand ice chute – left hand units have connections in same position on right side
Required Clearances
• 51" (1295mm) minimum above counter for installation if dispenser will be dropped into counter
• 36" (915mm) minimum above counter for auger removal
• 12" (305mm) minimum on side opposite ice chute for service
• 12" (305mm) minimum on ice chute side if ice transport tube enters this side
• 12" (305mm) minimum between dispenser side(s) and optional icemaker(s)
• Maximum counter thickness – 1.25" (31.75mm)
Electrical
Standard electrical – 115V, 60Hz, 1 ph
Dispenser – 2.4 amps
Alternate electrical – 220V, 60Hz, 1 ph
Dispenser – 2.0 amps
8 ft (2.4m) cord and NEMA 5-15 hospital-grade plug provided with each dispenser. Separate circuits and disconnects required for
each dispenser.
Approximate Shipping Weight
Dispenser – 250 lbs (113kg)
Chewblet is a registered trademark of Follett Corporation, registered in the US.
Follett reserves the right to change specifications at any time without obligation. Certifications may vary depending on country of origin.
801 Church Lane • Easton, PA 18040, USA
Toll free (800) 523-9361 • (610) 252-7301
Fax (610) 250-0696 • www.follettice.com
115V only
115V only
© Follett Corporation
Form #2790
05/07
Loading...