Page 1
INSTRUCTIONS
FOODSERVICE, LLC
FPS-Plus Polymer Shelving with SaniGard™
Note: Please dispose of loose, round plastic pieces. These are used to
separate the shelves for shipping purposes.
Helpful Hint: When placing the plastic tapered sleeves onto the posts
(Step 1), slide the plastic tapered sleeves up or down on the post until you
feel it “snap” into the lines or grooves of the post. It is normal to have a
slight gap in-between the two pieces of the plastic tapered sleeves when
it is placed on the post.
Step 1 Choose the desired height of the bottom shelf (for added
stability, it is recommended that the bottom shelf is installed
no more than 6˝(2 – 3 lines) from the floor and the top
shelf no more than 6˝(2 – 3 lines) from the top.) Snap two
(2) plastic tapered sleeves, with the arrows facing up, at the
desired height on each post. (See Diagram #1) Shelves can
be adjusted every 1˝. (Note: Double grooves in the posts are
placed every 8th groove for simple shelf height reference.)
Step 2 Place shelf on its side, making sure the wider portion of the
four (4) round shelf collars are facing the bottom of the unit,
slide the top of the posts through the round shelf collars on
each corner of the shelves. Push the shelves firmly onto the
plastic tapered sleeves. (See Diagram #2)
Step 3 After installing the bottom shelf, set the unit upright
Step 4 Snap the plastic tapered sleeves into place on posts at the
next desired shelf height. Slide the shelf down from the top
of the posts onto the plastic tapered sleeves and repeat this
step for the remaining shelves. (Note: A rubber mallet may be
used to tap each corner of the shelves so they firmly install
onto the plastic tapered sleeves.) (Note: The leg levelers may
need to be utilized in order to make the unit level or flush
against the wall.)
ASSEMBLY
Anti-Microbial Protection
WARNINg: HEAVY OBJECTS MUST BE PLACED--NOT
DROPPED--ONTO THE SHELVES!!
DIAgRAM 1
Top
Top
DIAgRAM 2
continued on backside
Page 2
ASSEMBLY INSTRUCTIONS
Model# FTPRCST5 5" TPR Stem Casters with Bumpers
Model# FSCAST5 5" Polyurethane Stem Casters with Bumpers
Model# FTCAST5 5" Polyurethane Threaded Casters with Bumpers
Step 1 Slide a plastic bumper up the bottom of post about 4˝ - 6˝, smooth side facing up.
Step 2 For Stem - Install caster by inserting it into the hole in the bottom of the post.
For Threaded - Remove leveling assembly by turning it counter-clockwise.
Install caster by screwing it into the hole at the bottom of the post.
Step 3 Slide the plastic bumper down to the bottom of the post.
Step 4 Repeat these steps to install the remaining 3 casters.
Step 5 Then assemble shelving unit.
Note: The casters can be locked in place by turning the steel lock mechanism counter clockwise on the side of two
of the casters.
Weight capacity - Stem - 300 lbs. per caster
Threaded - 200 lbs. per caster
5" Polyurethane
Stem Casters
with Bumpers
5" Polyurethane
Threaded Casters
with Bumpers
FOODSERVICE, LLC
Call Customer Service at 1.800.968.3918 | Fax 1.800.968.4129
www.focusfoodservice.com
rev. 0111
Loading...