Focal High-Cap User Manual
focal power Symmetric HiGH-cap
User manual
We thank you for choosing Focal amplifiers for your Car Audio system and for sharing our philosophy:
“the Spirit of Sound”.In order to obtain the best results, we highly recommend you have your new
amplifier installed by your local Focal distributor.
The Focal Guarantee only applies if the last page
is returned to us within 10 Days of purchase.
WARNING
This symbol denotes important instructions. Non respect of these instructions may lead to serious
injuries and even fatal injuries.
CAUTION
This symbol denotes important instructions. Non respect of these instructions may lead to injury or
material damage.
Français page 4
Focal-JMlab® - BP 374 - 108, rue de l'Avenir - 42353 La Talaudière cedex - France - www.focal-fr.com
Due to constant technological advances, Focal reserves its right to modify specifications without notice. Images may not conform exactly to specific product..
Tel. (+33) 04 77 43 57 00 - Fax (+33) 04 77 43 57 04
focal power Symmetric HiGH-cap
User manual
High Cap:
The High-Cap is an external power supply module. Once connected to the amplifier, it increases regulation
capacitance of rail's power supply. It brings high music performance, a very high performance maintaining and
an extremely high-fidelity of the audio signal. The High-Cap module is sold separately.
WARNING
For your safety and in order not to damage the equipment, you MUST follow the steps below.
CAUTION
In the event of a wrong handling, an electric arc may occur.
4 - HIGH-CAP connection
4.1 - Turn off the car radio in order to shut down all the elements. Switch off the engine of your vehicle and
remove the key.
4.2 - Unplug the negative cable of the battery before starting the installation (pic.1).
4.3 - Remove the fuse of the amplifier power cable being careful not to make the cable touch the main
body.
4.4 - Unplug the power cable, the ground cable and the remote cable from the amplifier (pic.2).
2
4.5 - Wait 30 seconds and then connect the HIGH-CAP(s).
4.6 - Plug the power cable, the ground cable and the remote cable to the amplifier through the adapted
terminals.
4.7 - Plug the negative cable of the battery.
CAUTION: A small electric arc may occur.
4.8 - Insert the fuse into the fuse-holder(s), and screw in tightly.
4.9 - Turn on the different elements. Once all the elements are on, carry out a test at low volume.
5 - Unplug the HIGH-CAP
5.1 - Turn off the car radio in order to shut down all the elements. Switch off the engine of your vehicle and
remove the key.
5.2 - Unplug the negative cable of the battery before starting the handling (pic.1).
5.3 - Remove the fuse of the amplifier power cable being careful not to make the cable touch the main
body.
focal power Symmetric HiGH-cap
User manual
5.4 - Unplug the power cable, the ground cable and the remote cable from the amplifier.
5.5 - Wait 30 seconds and then unplug the HIGH-CAP(s) (pic.2).
5.6 - Plug the power cable, the ground cable and the remote cable to the amplifier through the adapted
terminals.
5.7 - Plug the negative cable of the battery.
CAUTION: A small electric arc may occur.
5.8 - Insert the fuse into the fuse-holder(s), and screw in tightly.
5.9 - Turn on the different elements. Once all the elements are on, carry out a test at low volume.
3
Pic. 1
Pic. 2
Loading...