Flymo Trimmer, ET21 Original Instructions Manual

IMPORTANT INFORMATION

Read before use

& retain for future reference

®

Original Instructions

Carton Contents

IMPORTANT !

Please check the contents of the carton are correct BEFORE assembling your new
product.
IF ANY PARTS ARE MISSING CONTACT:­Husqvarna UK Ltd. Customer Service Department direct
Telephone : [phone] Fax : [phone]

Safety

WARNING.When using the product the safety rules must be followed. For your own safety and that of
bystanders please read these instructions before operating the product. Please keep the instructions
safe for later use.

Explanation of Symbols on your product

Warning

Read the user instructions carefully to
make sure you understand all the con­trols and what they do.

Keep others, including children, pets
and bystanders outside the 10 metre
hazard zone. Stop the trimmer immedi­ately if you are approached.

The use of eye protection is recom­mended to protect against objects
thrown by the cutting line.

To avoid the possibility of electric
shock, do not use in damp or wet con­ditions.

Switch off! Remove plug from mains be­fore adjusting, cleaning or if cable is en­tangled or damaged.

Warning: The cutting line continues to rotate after
the machine has been switched off.

360º

10m

Upper Shaft

Switch Lever

Electric Cable with
moulded on plug

Guard

Instruction
Manual

Lower
Shaft

General

1. This product is not intended for use by persons
(including children) with reduced physical, sen­sory or mental capabilities, or lack of experi­ence and knowledge, unless they have been
given supervision or instruction concerning the
use of the product by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the product.
Local regulations may restrict the age of the op­erator.

2. Never allow children or people unfamiliar with
the instructions to use the machine.

3. Stop using the machine while people, espe­cially children, or pets are nearby.

4. Only use the trimmer in the manner and for the
functions described in these instructions.

5. Never operate the trimmer when you are tired,
ill or under the influence of alcohol, drugs or
medicine.

6. The operator or user is responsible for acci­dents or hazards occurring to other people or
their property.

Electrical
AVOID ACCIDENTAL STARTING, REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN:- CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP, MANUALLY FEEDING OR
REPLACING NYLON LINE

1. The British Standards Institute recommend the
use of a Residual Current Device (R.C.D.) with a
tripping current of not more than 30mA. Even
with a R.C.D. installed 100% safety cannot be
guaranteed and safe working practice must be
followed at all times. Check your R.C.D . every
time you use it.

2. Before use, examine cable for damage, replace it
if there are signs of damage or ageing.

3. Do not use the trimmer if the electric cables are
damaged or worn.

4. Immediately disconnect from the mains elec­tricity supply if the cable is cut, or the insulation
is damaged. Do not touch the electric cable
until the electrical supply has been discon­nected. Do not repair a cut or damaged cable.
Replace it with a new one.

5. Your extension cable must be uncoiled, coiled
cables can overheat and reduce the efficiency
of your trimmer.

6. Keep the cable clear of the cutting area and ob­stacles at all times.

7. Do not pull cable around sharp objects.

8. Always switch off at the mains before discon­necting any plug, cable connector or extension
cable.

9. Never pull on the cable to disconnect any of the
plugs.

10.Switch off, remove plug from mains and exam­ine electric supply cable for damage or ageing
before

winding cable for storage. Do not repair
a damaged cable, replace it with a new one.
Use only our replacement cable.

11.Always wind cable carefully, avoiding kinking.

12.Use only on AC mains supply voltage shown on
the product rating label.

13.Our trimmers are double insulated to EN60335.
Under no circumstance should an earth be con­nected to any part of the trimmer.

Preparation

1. While using your product always wear substan­tial footwear and long trousers.

2. Before using the machine and after any impact,
check for signs of wear or damage and repair
as necessary.

3. Inspect the area to be cut before each use. Re­move all objects such as stones, broken glass,
nails, wire, string etc, which can be thrown or
become entangled in the trimmer head.

4 . Before use, inspect the area for wildlife, espe-

cially hedgehogs.

5. Check that the cutting head is fitted correctly.

Use

1. Use the trimmer only in daylight or good artificial
light.

2. Avoid operating your trimmer in wet grass,
where feasible.

3. Take care in wet grass, you may lose your foot­ing.

4. On slopes, be extra careful of your footing and
wear non-slip footwear.

5. Do not walk backwards when trimming, you
could trip. Walk never run.

6. Keep cutting head below waist level.

7. Switch off before pushing the trimmer over sur­faces other than grass.

8. Never operate the trimmer with damaged
guards or without guards in place.

9. Never fit metal cutting elements.

10.Keep hands and feet away from the cutting
means at all times and especially when switch­ing on the motor.

11.Never pick up or carry a trimmer by the cable.

12.Do not lean over the trimmer guard - objects
may be thrown by the cutting line.

13.Remove the plug from the mains :

- before leaving the trimmer unattended for any
period;

- before clearing a blockage;

- before checking, cleaning or working on the appli­ance;

- if you hit an object. Do not use your trimmer
until you are sure that the entire trimmer is in a
safe operating condition;

- if the trimmer starts to vibrate abnormally.
Check immediately. Excessive vibration can
cause injury.

Maintenance and storage

1. Keep all nuts, bolts and screws tight to be sure
the trimmer is in safe working condition.

2. Replace worn or damaged parts for safety.

3. Only use the replacement cutting line specified
for this product.

4. Only use replacement parts and accessories
recommended by Husqvarna UK Ltd.

5. After any maintenance in dealing with the cut­ting line, always return the product to its normal
operating position before switching on.

6. Clean unit with a dry cloth. Never use metal ob­jects to clean the unit.

7. Inspect and maintain the trimmer regularly. Any
repairs must be carried out by an authorised

re-

pairer.

8. Store in a cool dry place and out of reach of chil-

dren. Do not store outdoors.