®
Chevron 34C
Chevron 34VC
Chevron 37C
Original Instructions
Chevron 37VC
MPOR
I
d
a
e
R
ret
&
N
O
I
T
MA
FOR
N
I
T
N
A
T
re use
o
f
e
b
in
a
ut
f
r
o
f
ure
e
r
ce
n
e
r
e
f
cable clip x 2
start/stop lever
cable hook x 2
wing knob x 2
bolt x 2
Carton Contents
switchbox
lock off button
screw small x 2
upper handle
washer x 2
lower handle
safety flap/vision window
VC Product only
grassbox
upper
grassbox
lower
electric cable with
moulded on plug
motor cover
height adjust lever
screw large x 2
rating label
deck
IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:Husqvarna UK Ltd. Customer Service Department direct
Telephone : 0844 844 4558 UK 1800 882 350 ROI Fax : 01325 302530
instruction
manual
Safety
If not used properly this product can be dangerous! This product can cause serious injury to the operator
and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency
in using this product. The operator is responsible for following the warning and safety instructions in this
manual and on the product. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position.
Explanation of Symbols on your product
Warning
Read the user instructions carefully to make
sure you understand all the controls and what
they do.
Beware of sharp blades - remove plug from
mains before maintenance or if cable is damaged.
Blades continue to rotate after the machine is
switched off.
Always keep the product on the ground when
operating. Tilting or lifting the product may cause
stones to be thrown out.
Keep bystanders away. Do not operate whilst
people especially children or pets are in the
area.
General
1. This product is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of
the product by a person responsible for their safety. Children
should be supervised to ensure that they do not play with
the product. Local regulations may restrict the age of the operator.
2. Never allow children or people unfamiliar with the instruc-
Keep the cable supply away from the blade.
tions to use the machine.
3. Stop using the machine while people, especially children, or pets are nearby.
4. Only use the product in the manner and for the functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Electrical
1. We recommend the use of a Residual Current Circuit Device (R.C.D.) with a tripping current of not more than 30mA.
Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times.
Check your R.C.D. every time you use it.
2. Before use, examine cable for damage or ageing. If
the cable is found to be defective, take the product to
an Authorised Service Centre and have the cable replaced.
3. Do not use the product if the electric cables are damaged or worn
4. Immediately disconnect from the mains electricity supply if
the cable is cut, or the insulation is damaged. Do not
touch the electric cable until the electrical supply has been
disconnected. Do not repair a cut or damaged cable. Replace it with a new one.
5. Your extension cable must be uncoiled, coiled cables
can overheat and reduce the efficiency of your product.
6. Keep cable away from product, always work away from
the power point mowing up and down, never in circles.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting any
plug, cable connector or extension cable.
9. Switch off, remove plug from mains and examine electric supply cable for damage or ageing b
cable for storage. If the supply cord is damaged, it
must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a
hazard. Use only Flymo replacement cable.
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of the plugs.
13. Use only on AC mains supply voltage shown on the
product rating label.
14. Flymo Products are double insulated to EN60335.
Under no circumstance should an earth be connected
to any part of the product.
P
reparation
1. While using your product always wear substantial
footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals.
2. Make sure the lawn is clear of sticks, stones, bones,
wire and debris; they could be thrown by the blade.
3. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
4. Replace worn or damaged blades together with their
fixings in sets to preserve balance.
CABLES - IMPORTANT
If you want to use an extension cable when operating your
product, only the following cable dimensions should be used.
- 1.0 mm
- 1.5 mm
- 2.5mm
M
1.00mm
• Y
1. Flymo Mains Cables and Extension Cables are avail-
2. Do not wire an extension cable directly to your product
3.
CONNECTORS - IMPORTANT
• Flymo connectors are suitable for use with 2 core cable
• All Flymo connectors and cables are of splashproof
M
• If the plug supplied is cut off it should be destroyed.
2
: max length 40 m
2
: max length 60 m
2
: max length 100 m
inimum rating :
2
size cable, 10 amps 250 volts AC.
OUR PRODUCT IS SUPPLIED WITH CABLE WIRED
DIRECTLY INTO THE PRODUCT.
able from your local Approved Service Centre.
yourself. Please contact your local Approved Service
Centre for further information on the connectors and kits
available.
Only use extension cables specifically designed for outdoor
use and which conform to one of the following specifications:
Ordinary rubber (60245 IEC 53), Ordinary PVC (60227
IEC 53) or Ordinary PCP (60245 IEC 57)
only. Under no circumstances should these connectors
be used for earthed products.
construction. They are not waterproof and must not be
left outside permanently nor should they be submerged
or immersed in water. Do not let cable lay or trail through
pools of water or splashed with water from hose pipes.
AINS PLUG REPLACEMENT - IMPORTANT
efore
winding
U
se
1. Use the product only in daylight or good artificial light.
2. Avoid operating your productin wet grass, where feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and wear
non-slip footwear.
5. Mow across the face of slopes, never up and down.
6. Exercise extreme caution when changing direction on
slopes. Walk never run.
7. Mowing on banks and slopes can be dangerous. Do
not mow on b
8. Do not walk backwards when mowing, you could trip.
9. Never cut grass by pulling the product towards you.
10. Switch off before pushing the product over surfaces
other than grass.
11. Never operate the product with damaged guards or
without guards in place.
12. Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
13. Do not tilt product when the motor is running.
14. Do not put hands near the grass discharge chute.
15. Never pick up or carry a product when it is operating or
still connected to the mains supply.
16. Remove the plug from the mains :
- before leaving the product unattended for any period;
- before clearing a blockage;
- before checking, cleaning or working on the appliance;
- if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
condition;
- if the product starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury.
M
aintenance and storage
1. Caution - Do not touch rotating blade.
2. Keep all nuts, bolts and screws tight to be sure the
lawnmower is in safe working condition.
3. Check the grassbox frequently for wear or deterioration.
4. Replace worn or damaged parts for safety.
5. Only use the replacement blade, and blade bolt specified for this product.
6. Be careful during adjustment of the product to prevent
entrapment of the fingers between moving blades and
fixed parts of the machine.
7. Store in a cool dry place and out of reach of children.
Do not store outdoors.
8. Allow the product to cool for at least 30 minutes before
storing.
There is an electric shock hazard if a cut off plug is inserted into a 13 amp socket.
1. No earth required. Flymo products are double insulated
to EN60335 and under no circumstances should an
earth be connected to any part of the product.
2. E
nsure the mains voltage suits your product
3. IMPOR
The wires in the mains lead are coloured in accordance
with the following code:
BLUE - NEUTRAL
BROWN - LIVE
The wire which is coloured BLUE must be connected to
the Terminal which is marked with the letter 'N' or
coloured BLACK.
The wire which is coloured BROWN must be connected
to the Terminal which is marked with the letter 'L' or
coloured RED.
4. It is important that the outer sheath is clamped correctly
into the 3-pin plug.
5. If in doubt consult your local Service Repairer or quali-
fied electrician before the machine is used.
6. A 13 Amp fuse must be fitted to the Mains Plug.
7. The normal plug fuse and household fuse only protect
the electrical equipment and are not a safeguard
against electrocution.
If your product is hard wired i.e. non-detachable mains
electric cable, a conversion kit and extension cable is
available from all Approved Service Centres which
can be found in your local Yellow Pages.
TANT!
anks
or steep slopes.
Loading...