flyingwings WRA-SPEC WING User Manual

Thank you for purchasing the WRA-SPEC WING
The SPEC wing is designed for the UK wing racing series.

The idea is to provide a homologated wing kit to allow you to participate in the
“spec series” wing racing league.

Its also an exciting & low cost wing to build and fly, whether for FPV or normal sport
flying.

Recommended Setup

2 x Micro size servos , 8-9g metal geared recommended
1 x Small receiver
1 x Lipo battery(s) 2200mah 3s (Grahene or high performance, not allowed)
1 x 2212-6 2200kv outrunner motor + APC 6x4 speed propeller
1 x 30amp speed controller
1 x connectors set
1 x Transmitter capable of elevon mixing or mixing module
1 x Lipo compatible charger
1 x 25mw FPV system

Power System: (inc with deal).

LETS GET BUILDING

WRA_ -SPEC RACE WING

Flyingwings recommends

that you get insured by the

BMFA.

www.bmfa.org

UHU POR

HOT GLUE GUN

CA GLUE

Ver 1.0

Top

Top

Bottom

Bottom

STEP

STEP

1

2

Glue the two wing halves, using uhu por
or hot glue

Turn the wing upside down and glue in the
carbon strip spars, Uhu Por is best for this

Bottom

Top

30mm

80mm

110mm

40mm

when cutting be aware of
the spars in the bottom of
the wing

Cut Battery bay

STEP

STEP

3

4

Glue on ply plates, as shown

Dimensions given are for
a typical 2200mah 3S
battery