flyingwings Venturi EVO 2 FPV Assembly Manual

Venturi EVO FPV2

CRITICAL DATA

CENTRE OF GRAVITY 185 +/-10mm
BACK FROM THE FOAM WING LEADING
EDGE AT ROOT

TARGET FLYING WEIGHT
2000 grams without FPV gear & camera
with 2 x 3300mah 4S batteries

UHU POR

HOT GLUE GUN

CA GLUE

PVA WOOD GLUE

Thank you for purchasing the Venturi EVO FPV wing

The Venturi FPV is designed for First Person Viewing (FPV) and for UAV/Drone
experimentation.

There is a power system for this model, see the website for details.

As well as this power system you will require:

2 x Standard size servos 43g (standard size)
1 x Long range receiver
1 x Lipo battery(s) (2x 3300mah 3S or 4S 11.1v)
1 x connectors set
1 x Transmitter capable of elevon mixing or mixing module
1 x Lipo compatible charger

See website for power system details

STEP

STEP

1

2

Fuselage assembly

Carefully cut the tabs holding
the parts on to the sheets of ply.

Sand off the remaining tab and
lightly bevel off the interlocking
part of the piece, to help in
assembly.

Glue the 2 motor plates together using wood glue or UHU por, be careful to
align them accurately, allow to dry

Sand the tabs down as shown

Tabs

Once you have trimmed and sanded the ply parts, its ready for assembly.

Lay the fuselage side on a flat surface and assemble without glue.

Once you have trimmed and sanded the ply parts,
its ready for assembly.

Lay the fuselage side on a flat surface and
assemble without glue.