flyingwings Hornet Mini FPV Racer User Manual
Thank you for purchasing the Hornet Mini FPV Racer
Race your mates around a pylon circuit, or through the 250 quad gates, if you dare !
The Hornet is designed to be kept light, using a micro FPV TX and camera, the
lighter, the faster.
As well as this power system you will require:
2 x micro servos 5-8g
1 x micro Receiver
1 x Lipo battery (800mah 3S 11.1v)
1 x Mini FPV system such as the Elgae FOV160-200
1 x Transmitter capable of elevon mixing or mixing module
1 x Lipo compatible charger
1 x FPV Receiver, & goggles
Power System: (inc with deal).
1 x 1806 2280kv brushless motor
1 x 12amp speed controller
1 x GemFan 5x3 or similar prop
LETS GET BUILDING
Hornet Mini FPV Racer
Flyingwings recommends
that you get insured by the
BMFA.
www.bmfa.org
CRITICAL DATA
CENTRE OF GRAVITY 130mm BACK
FROM THE NOSE POINT
TARGET FLYING WEIGHT
240-260 GRAMS
UHU POR
HOT GLUE GUN
CA GLUE
STEP
STEP
1
2
1. Turn the wing over and insert the
carbon strip spar.
Cut the battery & radio
compartment out to lines drawn on
the wing. Then join the wing.
Use the full size template on
the template sheet
STEP
STEP
3
4
STEP
4
Glue the ply side panels to the
fuselage,
Glue motor mount as shown and then
the ply plate.
Glue the fuselage to the underneath of the wing centrally, note that this leaves a
gap, allowing the installation of a standard board camera
gap
Loading...