FLY SL300m Service Manual Disassembly

Model ESL808 Version V_0.01

Prepared by H/W Date 20/09/2005

Subject Technical Manual Page 1/10

Disassembly

This section covers the assembly and disassembly of ESL808 phone. In order to carry out the
assembly or disassembly the following precautions should be taken:

1. A Plus screwdriver is required to remove the four retaining screws, which holds the two casings

together. Ensure that the screwdriver is narrow enough to reach the screws without causing
damage to the casing parts.

2. The phone should always be placed on a soft surface to minimise the risk of damage being caused

to the casing, window and keypad. If the PCB is to be removed, then care should be taken not to stress

or scratch the exposed LCD.

3. Observe anti-static precautions when handling the main PCB or any of its components.

4. Repairs must only be undertaken by Ezze M Tech approved service centres.

5. Repairs carried out by unauthorised persons will result in the warranty on the unit becoming void.

6. Do not use solvents to clean any of the casing parts or the LCD window.

Model ESL808 Version V_0.01

Prepared by H/W Date 20/09/2005

Subject Technical Manual Page 2/10

Phone disassembly

1. Battery Cover and Battery Disassembly

A. Pull up the lock knob in the arrow direction.
B. Remove the battery

2. Sim card & Screw & Sheet & Io cap & Rear Cover & Internal Antenna & Disassembly

A. Remove the sim card.
B. Remove the caps and sheet and unscrew the Four screws. Carefully separate the two covers

- front and rear.

C. Remove the internal antenna along the arrow direction

Model ESL808 Version V_0.01

Prepared by H/W Date 20/09/2005

Subject Technical Manual Page 3/10

3. Side Key & Caps Disassembly

A. Remove the caps and side key along the arrow direction.

5. Main PCB Disassembly
A. From the front cover, separate the main PCB.

.