DSX-PLA-004-RKIT
DSX-PLA-804-RKIT
DTX-PLA002PRP
Replacement Parts for DSX and DTX
Permanent Link Adapters
Installation Guide
These kits are sets of RJ45 tips, latches, and cases that replace
worn parts on these DSX and DTX permanent link adapters:
Kit Adapter
DSX-PLA-004-RKIT DSX-PLA004
DSX-PLA-804-RKIT DSX-PLA804
DTX-PLA002PRP DTX-PLA002
PN 4969875 January 2018
©2018 Fluke Corporation
All product names are trademarks of their respective companies.
The kits include these items:
Two RJ45 tips
Two latches
Two screws
Two conductive washers
Symbols
Warning or Caution: Risk of damage or destruction to
W
equipment or software. See explanations in the manuals.
Consult the user documentation.
This product complies with the WEEE Directive marking
~
requirements. The affixed label indicates that you must
not discard this electrical/electronic product in domestic
household waste. Product Category: With reference to the
equipment types in the WEEE Directive Annex I, this
product is classed as category 9 "Monitoring and Control
Instrumentation" product. Do not dispose of this product
as unsorted municipal waste. To return unwanted
products, contact the manufacturer’s web site shown on
the product or your local sales office or distributor.
40 year Environment Friendly Use Period (EFUP) under
China Regulation - Administrative Measure on the Control
of Pollution Caused by Electronic Information Products.
This is the period of time before any of the identified
hazardous substances are likely to leak out, causing
possible harm to health and the environment.
Two top and bottom cases
(DSX kits only)
Two conductive pads
(DSX-PLA-804-RKIT only)
Installation instructions
2
How to Replace the Tip and Latch
* Conductive pads. DSX-PLA-804-RKIT only.
Conductive
washer
Latch
Tip
Pin
Hole
WCaution
Do not break
the pin.
1
Remove the adapter from the tester.
2
Use a Phillips screwdriver to loosen the screw on the
connector case; then remove and replace the tip or latch
as shown below.
3
Make sure that the conductive washer is on the case screw
as shown below.
For DSX-PLA804 adapters, make sure to put the
conductive pads in the case top and bottom.
4
Reassemble the connector case, then tighten the screw.
How to Replace the Tip and Latch
HFN00.EPS
3
Specifications
Life of tip contacts (typical): > 5,000 cycles
For more performance specifications on the DSX or DTX
adapters, see the Versiv Series Technical Reference Handbook
or the DTX Technical Reference Handbook or visit the Fluke
Networks website.
Contact Fluke Networks
www.flukenetworks.com/support
info@flukenetworks.com
1-800-283-5853, +1-425-446-5500
Fluke Networks
6920 Seaway Boulevard, MS 143F
Everett WA 98203 USA
Fluke Networks operates in more than 50 countries
worldwide. For more contact information, visit our website.
LIMITED WARRANTY
Parts, accessories, product repairs and services are warranted
for 90 days, unless otherwise stated. See the product manual
for details.
4/15
Fluke Networks
PO Box 777
Everett, WA 98206-0777
USA
4
Loading...