Fluke FLK-TI-SBC3, FLK-TI-SBP3 User Manual

FLK-TI-SBC3

POWER

Ti SBC3

SMART BATTERY

CHARGER 3

Charging Base/Power Supply with Adapters

Instruction Sheet

The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a
charging base, power supply, and power outlet adapters.

PN 3481481 August 2009

© 2009 Fluke Corporation. All rights reserved. Printed in USA.

All product names are trademarks of their respective companies. Specications are subject to change without notice.

Safety Information

Use the FLK-TI-SBC3 only as specied in this instruction sheet or other Fluke
product-specic manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.

A Warning identies hazardous conditions and actions that could cause bodily harm or
death.

A Caution identies conditions and actions that could damage the Imager or cause
permanent loss of data.

W Warning

To avoid injury:

Do not disassemble or short circuit the battery pack. ●
Do not expose the battery pack to temperatures above 50 °C (122 °F). ●
Do not incinerate or mutilate the battery pack. ●
Use only ac adapters approved by Fluke for the product to charge the battery or ●
power the product.

Table 1. Symbols

Symbol Description

P

"

;

)

W

~

Conforms to requirements of European Union and European Free Trade Association.

Imager connected to battery charger.

Conforms to relevant Australian standards.

Conforms to relevant Canadian and US standards

Important information. See manual.

Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
recycling information.

Charging the Battery

Before using the battery pack for the rst time, charge the battery in the two-bay charging

base for at least two and one-half hours. For complete charging instructions, see the “Ti32,
TiR32 Thermal Imagers User Manual.”

Specications

See Table 2 for the specications.

Table 2. Specications

Battery Charging

Charging / Power LED

Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)

Operating Temperature -10 °C to 70 °C (-14 °F to 158 °F)

Storage Temperature -20 °C to 80 °C (-4 °F to 176 °F) without batteries

Humidity Range 10 % to 95 % non-condensing

10-15 Vdc 2 A or charge battery pack in Imager with included ac

adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.

Status Charging LED Power LED

off no battery detected no dc power input

solid green charged dc power present

blinking green charging na

blinking red fault na

How to Contact Fluke

To contact Fluke, call one of the following telephone numbers:

USA: 1-800-760-4523•

Canada: 1-800-36-FLUKE (1-800-363-5853)•

Europe: [phone]•

Japan: [phone]•

Singapore: [phone]•

Anywhere in the world: [phone]•

Or, visit Fluke’s website at www.uke.com.

To register your product, visit http://register.uke.com.

To view, print, or download the latest manual supplement, visit

http://us.uke.com/usen/support/manuals.

LIMITED WARRANTY AND LIMITATION OF LIABILITY

This Fluke product will be free from defects in material and workmanship for one year
from the date of purchase. This warranty does not cover fuses, disposable batteries, or
damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions

of operation or handling. Resellers are not authorized to extend any other warranty on

Fluke’s behalf. To obtain service during the warranty period, contact your nearest Fluke

authorized service center to obtain return authorization information, then send the product

to that Service Center with a description of the problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH AS
FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR IMPLIED. FLUKE
IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY. Since some states
or countries do not allow the exclusion or limitation of an implied warranty or of incidental
or consequential damages, this limitation of liability may not apply to you.

Fluke Corporation
P.O. Box 9090
Everett, WA 98206-9090
U.S.A.

11/99

Fluke Europe B.V.
P.O. Box 1186
5602 BD Eindhoven
The Netherlands