Fluke FEV-CON-TSL User manual

FEV-CON-TSL

Test Plug For Tesla™ Station

Safety Information

Introduction

The FEV-CON-TSL (the Product) is high-quality accessory to test the
function and safety of charging equipment for electric vehicles. This
accessory is for use with with the Fluke FEV100 EV Charging adapter.

Tesla™ is a registered trademark of Tesla, Inc.

Safety Information

A Warning identies conditions and procedures that are dangerous
to the user. A Caution identies conditions and procedures that can
cause damage to the Product or the equipment under test.

To prevent the possibility of electric shock or personal injury:

• Read all safety information before you use the Product.

• Do not alter the Product and use only as specied, or the
protection supplied by the Product can be compromised.

• Carefully read all instructions.

• Do not use the Product if it operates incorrectly.

• Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.

• Limit operation to the specied measurement category,

voltage, or amperage ratings.

• Do not exceed the Measurement Category (CAT) rating

of the lowest-rated individual component of a Product,
probe, or accessory.

• Comply with local and national safety codes. Use
personal protective equipment (approved rubber

gloves, face protection, and ame-resistant clothes) to

prevent shock and arc blast injury where hazardous live

WX Warning

PN 5361946, May 2022
© 2022 Fluke Corporation. All rights reserved.

Specications are subject to change without notice.

All product names are trademarks of their respective companies.

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

conductors are exposed.

• Remove the input signal before you clean the Product.

• Do not use cable assembly if they are damaged. Examine

the cable assembly for damaged insulation, exposed

metal. Check cable assembly continuity.

• Measure a known voltage rst to make sure that the

Product operates correctly.

• Do not use the Product around explosive gas, vapor, or in

damp or wet environments.

• Do not use the Product if it is altered or damaged.

• Do not use cable assembly if there is damage. Examine

the cable assembly for damaged insulation and measure
a known voltage.

• Only connect the Product to the instrument and the

charging stations as indicated in the Specication section.

• Use the Product within the operating range only. The

operating range is specied in the Specication section.

Symbols

Symbol Description

WARNING. RISK OF DANGER.

W

WARNING. HAZARDOUS VOLTAGE.

X

Risk of electric shock.
Consult user documentation.



Measurement Category II is applicable to test and



measuring circuits connected directly to utilization points
(socket outlets and similar points) of the low-voltage
MAINS installation.

This product complies with the WEEE Directive and its

marking requirements. The a󰀩xed label indicates that

you must not discard this electrical/electronic product
in domestic household waste. Do not dispose of this



product as unsorted municipal waste. For information

about take-back and recycling programs available in
your country, see the website.

Product Disposal

Dispose of the Product in a professional and environmentally
appropriate manner:

• Delete personal data on the Product before disposal.

• Put the Product in the electrical waste.

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

Transport and Storage

Please keep the original packaging for future transport (for

example, if calibration is necessary). Any transport damage due to
faulty packaging will be excluded from warranty claims.

The accessory must be stored in dry, closed areas. In case of an
accessory being transported in extreme temperatures, a minimum

recovery time of 2 hours is required prior to any operation.

Available Versions

• FEV-CON-TSL Test Plug For Tesla™ Station

Operation Elements and Connectors

1

Test cable connector to test adapter

1

EV connector for charging stations

2

type TESLA™ with xed cable and

vehicle connector

2

FEV-CON-TSL

Test Plug For

Tesla™ Station

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

How To Test

For operation please refer to instruction manual of the Fluke FEV100.

Maintenance

When using the test adapter in compliance with the user manual,
no special maintenance is required. However, should functional
errors occur during normal operation, the after-sales service will

repair your instrument. Please contact the local service o󰀩ce.

Cleaning

• Remove all input signals and measurement circuits

before you clean the Product.

• Never use acid-based detergents or solvent liquids for

cleaning.

• After cleaning, do not use the Product until the Product is

dried completely.

To clean the Product, use a wet cloth and a mild household
detergent.

WX Warning

Specications

General Features

Safety .................................... IEC 61010-1, IEC 61010-2-030,

Ratings ..................................CAT II 250 V, max 1000 mA

Operating temperature ..........-20 °C to 40 °C (-4 °F to 104 °F)

Storage temperature .............-20 °C to 50 °C (-4 °F to 122 °F)

Operating humidity range ...... 10 % to 85 % relative humidity

Storage relative humidity ...... 0 % to 85 % non-condensing

Operating altitude ..................2000 m (6561 ft) max.

Length ................................... Approx. 590 mm (23.2 in)

Weight ...................................Approx. 550 g (1.2 lb)

pollution degree 2

non-condensing

including connectors

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

LIMITED WARRANTY AND LIMITATION OF LIABILITY

Each Fluke product is warranted to be free from defects in material and

workmanship under normal use and service. The warranty period is one year

and begins on the date of shipment. Parts, product repairs, and services
are warranted for 90 days. This warranty extends only to the original buyer

or end-user customer of a Fluke authorized reseller, and does not apply to

fuses, disposable batteries, or to any product which, in Fluke's opinion, has
been misused, altered, neglected, contaminated, or damaged by accident or
abnormal conditions of operation or handling. Fluke warrants that software
will operate substantially in accordance with its functional specications for 90
days and that it has been properly recorded on non-defective media. Fluke
does not warrant that software will be error free or operate without interruption.

Fluke authorized resellers shall extend this warranty on new and unused
products to end-user customers only but have no authority to extend a greater
or di󰀨erent warranty on behalf of Fluke. Warranty support is available only if

product is purchased through a Fluke authorized sales outlet or Buyer has paid

the applicable international price. Fluke reserves the right to invoice Buyer for

importation costs of repair/replacement parts when product purchased in one

country is submitted for repair in another country.

Fluke's warranty obligation is limited, at Fluke's option, to refund of the purchase

price, free of charge repair, or replacement of a defective product which is
returned to a Fluke authorized service center within the warranty period.

To obtain warranty service, contact your nearest Fluke authorized service
center to obtain return authorization information, then send the product to
that service center, with a description of the di󰀩culty, postage and insurance

prepaid (FOB Destination). Fluke assumes no risk for damage in transit.

Following warranty repair, the product will be returned to Buyer, transportation
prepaid (FOB Destination). If Fluke determines that failure was caused by
neglect, misuse, contamination, alteration, accident, or abnormal condition of
operation or handling, including overvoltage failures caused by use outside the
product’s specied rating, or normal wear and tear of mechanical components,
Fluke will provide an estimate of repair costs and obtain authorization before
commencing the work. Following repair, the product will be returned to the
Buyer transportation prepaid and the Buyer will be billed for the repair and

return transportation charges (FOB Shipping Point).

THIS WARRANTY IS BUYER'S SOLE AND EXCLUSIVE REMEDY AND
IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED,

INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. FLUKE
SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES OR LOSSES, INCLUDING LOSS OF DATA,
ARISING FROM ANY CAUSE OR THEORY.

Since some countries or states do not allow limitation of the term of an implied

warranty, or exclusion or limitation of incidental or consequential damages,
the limitations and exclusions of this warranty may not apply to every buyer.
If any provision of this Warranty is held invalid or unenforceable by a court or
other decision-maker of competent jurisdiction, such holding will not a󰀨ect the
validity or enforceability of any other provision.

11/99

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com