Floe VSD8000, VSD10000 Assembly Instructions Manual

FLOE CRADLE PADS – OUTBOARD KIT

INSTRUCTION P/N: 611

-

02719

-00

© Manufactured by:

BUNK/CRADLE PAD DISCLAIMER

TOOLS REQUIRED

*LIFT NOT INCLUDED

VSD8000-10000

ASSEMBLY INSTRUCTIONS

KIT P/N 511-02719-00

-(2) 9/16” SOCKETS/
WRENCHES

-(2) 3/4” SOCKETS/
WRENCHES

-15/16” SOCKET/WRENCH

-TAPE MEASURE

-TORQUE WRENCH

-RECIPROCATING SAW OR
EQUIVALENT WITH METAL
BLADE (OPTIONAL, SEE
SHEET 4 & 7)

DUE TO THE LARGE VARIETY OF BOAT HULL DESIGNS, WE STRONGLY

RECOMMEND THAT YOU CONSULT WITH YOUR BOAT’S MANUFACTURER TO

ENSURE THAT YOU ARE SUPPORTING YOUR BOAT PROPERLY TO AVOID ANY

RELEASED 3/27/19

POTENTIAL DAMAGE.

SHEET 1 OF 8

Floe International Inc.
48473 State Hwy. 65
McGregor, MN 55760
www.floeintl.com

BILL OF MATERIALS

P/N

511-02719

-00 CRADLE PAD

– OUTBOARD KIT

NUMBER PART NUMBER QTY. DESCRIPTION

1 001-70119-00 12 HHCS, 3/8-16 x 4” 18-8 ss
2 001-70219-00 6 HHCS, ½-13 x 4” 18-8 ss
3 001-70305-00 4 HHCS, 5/8-11 x 1” 18-8 ss
4 001-71025-00 4 FLAT WASHER, 5/8” SAE 18-8 ss
5 001-76072-00 6 NUT, NYLOCK ½-13 ALUM.
6 001-76349-00 12 NUT, 3/8-16 ALUM.
7 001-76351-00 4 NUT, 5/8-11 ALUM.
8 002-04269-00 2 TUBE, CRADLE PAD SUPPORT – 36”

9 002-04285-00 6 CLAMP, BUNK CRADLE (MALE)
10 111-00358-00 6 ASS’Y, CRADLE PAD – 29.75”
11 111-00359-00 2 WELD’T, LG. BUNK TUBE CLAMP 2 HOLE
12 111-00360-00 2 WELDMENT, BUNK TUBE CLAMP (R)
13 111-00361-00 2 WELDMENT, BUNK TUBE CLAMP (L)

VSD8000-10000

EXPLODED VIEW

2X

2X

SHEET 2 OF 8

STEP 1

FIGURE 1.2

FIGURE 1.3

FIGURE 1.1

SLIDE CLAMPS TOGETHER (FIGURE 1.1), THEN SLIDE ONTO CRADLE BEAM WITH POCKETS FACING
OUTWARDS (FIGURE 1.2). NOTE THAT ON WELMENTS THE TUBES ARE ON BIASED TOWARDS CENTER OF
LIFT. TWO MORE SETS OF WELDMENTS AND CLAMPS ARE PLACED ON THE OPPOSITE CRADLE BEAM.
PLACE (2) 5/8” X 1” BOLTS AND (2) 5/8” WASHERS INTO EACH CLAMP WELDMENT POCKET (FIGURE 1.3).

2X

2X

2X

SHEET 3 OF 8